Radio install..HELPPPP

[SiC 92 AcCoRd]

What up,

I was trying to install my pioneer head unit and i found the 2 little screws above the stock head unit..I took those out and it still wouldnt come out! How do i remove my old radio so i can install the new one??

I'v done it before in my old sentra but it was EASY as hell

thanks for your help

[accordztech]

http://www.installdr.com/InstallDocs/Honda/PDF/466033.pdf
that should help!

hehe i fixed the link, u need adobe abrocat to read that file...

[accordztech]

i see u dont have adobe...looser..haha

Remove Factory Radio
The Honda radio is secured as one unit to the pocket (or optional CD player) below the radio. The
radio and pocket remove as one unit by sliding out through the front of the dash. The radio/pocket
assembly in this vehicle is secured to the dash with (2) 8mm bolts at the rear of the radio as seen
in the center photo above. To remove the radio, these bolts must be removed. However, in order
to gain access to these bolts, you would have to reach around to the rear of the dash behind the
radio and remove the bolts. Unfortunately, there is not enough room to gain access to these 8mm
bolts unless you have specialty tools only professional installers would have.
There is a VERY SIMPLE solution to remove the radio. Honda designed the radio so that the 8mm
bolts securing the bracket that attaches the radio/pocket assembly can be accessed from
underneath the radio through the ashtray location.
The Install Doctor STRONGLY recommends removing the radio by accessing the 8mm bolts
through the ashtray. A professional installer who has removed many radios in this vehicle would
probably choose to reach around the rear of the dash and remove the 8mm bolts with a specialty
tool. This would probably take that installer at 5-10 minutes and lots of patience.
Removing the radio by accessing the 8mm bolts through the ashtray is the fastest and easiest
method to remove the radio and does NOT require the use of a speciality tool.
A NOTE BEFORE YOU BEGIN:
A word on removing the Honda radio
Photo showing 8mm bolts that are
accessible by removing the ashtray.
8mm bolts securing the radio/pocket assembly to the metal
bracket inside the vehicles dash opening.


i sent him the pics through AIM...free up some computer memory to install abrocrat hahaha!

[accordztech]

so how did it go bro?

[Verb]

I can't get my ashtray screws out:(

they are in there so hard, I don't know how the hell I'm going to get them out. I wish I could just rip it off.

[patastinky]

radios are easy! hit me up and ill go over there and help you or do it for you bro

[Verb]

yeah, I got all mine out today

I went to plug in the head unit and forgot the wire harness, hopefully I can pick one up tomorrow.