opinions on ultra cheap motor upgrade

[mayberry]

well i jsut bought a motor off 92accorddx, his old f22a1. I want to have the head milled just to bump compression up a little and i want to run a 75 shot of nitrous. How much should i have the head milled and what compression will it give me. Also, i want make the most out of it with uberdate or something similar because i am definetly geting a delta 272 regrind and new springs and i have to get rid of the rev limiter. So to let u know what order im going to do this in is this
1. order regrind and springs
2. put the head back together and on the motor
3 put motor in car with fresh tbelt n waterpump
4. tune it to the best of my ability
5 nitrous

im not looking for any serious hp numbers out of this set up. just a better daily driver for the little bit of money i am spending on it.
im really looking for power up to 7k but i doubt that will happen. BUT I CaN WISH CANT I?

[TheInfamous]

ultra cheap would be swaping out the header and intake mani from
the old A6 onto the A1, from there u will have to start spending money....







;)

[HondaFan81]

have you been talking to Wikked? hahaha...sounds like a setup he'd say...not that it's bad....but yea that is a cheaper route of getting some power

[mayberry]

u should give me some money to spend willis(the infamous)