How do I get to the front speakers?

[gloryaccordy]

I'm rigging up a custom component set and I want to know how to get to the front speakers. I'm gonna look into it more tomorrow, but hopefully I think it should just involve some unscrewing. Anyone know?

[Maple50175]

Hey man Look for it in the DIY section of the forum also i belive its just 4 or 5 screws holding on the door. Hope it helps

[accordztech]

something like that..

http://www.b20accord.com/90locks4.jpg

[SoySauceCb7]

yeah dude you must remove all visible screws, one is covered by a cap on the inner door, one under a cap behind the chrome door handle, theres one in the door handle space where you put yoru fingers to close the door and once you have all the screws removed you have to pop the door out from the bottom, there are about four screws holdin the bottom on and then you have to slide the door handle back and out, disconnect the door handle connection rods and then slid the door up over the lock. Remember comb the door for caps that cover the screws and then pop out the bottom of the door.

[Wallace]

/\ this will only work if you have power windows

if you have manual windows like me, it's a bit trickier to get the door panel off.
first you take out all the visable screws, and pop the door handle thingy off.
then there's this clip behind the handle that you use to roll the window up. you have to use a screwdriver or something thin, to get this clip off. once it's off, the handle should come off, then you can slide the panel off.
it's hard to explain in words, maybe i'll do a tutorial/DIY one day.

[xplode]

dont forget the clips behind the door panel, you need to make sure not to break them, take them off one by one and the door panel will come rite off.. do opposite to install.

[accordztech]

haha i just yank on it, if it does come off they can be put back on the door easilly...if u loose a clip or 2, dont trip....it happends.

remember the door handle piece, i believe you have to unscrew it and then pull it forward towards the front of the car, and then lift it and u will find the auto lock switch, and this little piece of metal going into handle to open the door...move that plastic on top of it and then use a flat head or long nose to pull it up...

tada...