Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Ya........ this is not working with my wheels I've grinded off material just to make it not touch, and now just realizing I'd have to shave off more, the width of the wheel weight. That's... alot...
-
Correct. Fog lights do not work with your high beams on. Set by the manufacturer. It's a under-dash fuse/relay box which is the gateway between the headlight power side and the fogs. But also that the...
Leave a comment:
-
Ya. I decided I am going to grind off as much as I need to make things clear. The caliper has lots of material on that spot and you can't see that side when installed....
Leave a comment:
-
Ug... having the hardest time with this. Kind of bummed out.... My 17" wheels have a ...... "lip" as you get closer to the outside edge of the wheel. So where you would put the wheel sticky...Last edited by Raf99; 04-07-2024, 07:27 PM.
Leave a comment:
-
No diff to my knowledge. Especially for the fronts. The rear maybe one had drum brakes and one had disc right.
Leave a comment:
-
I did stop by the tuners today and showed him the pistons. He was amazed of course and was immediately said long term detonation. He asked the setup again as it's been 10 years since the initial tune...
Leave a comment:
-
Always appreciate ya stopping by
New inner drivers fender lining. This time I need to find a way to secure it better. Clean engine bay = less fasteners for this thing. At high speeds...
Leave a comment:
-
Big thanks to Jacob for helping put the engine in! I have a great method now where I don't need to tilt the engine. The trans side (no mount on) goes in the corner of the passenger side & the drivers...
Leave a comment:
-
I have this process now where I put the trans hanging off a board. The board is on a jack. I can usually get it to slide in with out much muscle.
Reason I can't take the trans...
Leave a comment:
-
Don't cheap out on brakes, wheels/tires, suspension or steering components. Not worth the tow job (nevermind your life).
Leave a comment:
-
It's fairly easy, same as the Acura yep. You're going to have to find a manual for specs. This page has some of them..
https://www.cb7tuner.com/vbb5/forum/...bers-post-here...
Leave a comment:
-
Sooo lot's of progress. Starting putting the engine back together without any issues. It's easier to do without the balancer shafts for setting timing etc. East to get TDC #1, the cams use the allen...
- 1 like
Leave a comment:
-
"At the same time it feels bad to be putting 33 year old springs on brand new shocks."
Listen to your brain.... 
replace both....
Leave a comment:
No activity results to display
Show More
Leave a comment: