CB7Tuner Forums

Go Back   CB7Tuner Forums > Search Forums

Showing results 1 to 25 of 500
Search took 0.12 seconds.
Search: Posts Made By: fleetw00d
Forum: Engine DIYs Yesterday, 09:32 PM
Replies: 14
Views: 4,827
Posted By fleetw00d
You can avoid undoing the flex pipe to catalytic...

You can avoid undoing the flex pipe to catalytic converter bolts (particularly if very rusted), by just removing the rubber hangers and letting the system flex downward; there is enough play in the...
Forum: Members' Rides 04-16-2019, 09:47 PM
Replies: 29
Views: 3,952
Posted By fleetw00d
I guess I should have done this long ago! Not...

I guess I should have done this long ago! Not sure how a coil will run the engine one day, then fail the next. I should probably right something up for Engine DIY.
Forum: Off Topic 04-16-2019, 09:33 PM
Replies: 4,166
Views: 368,480
Posted By fleetw00d
My wagon has a Honda muffler with lifetime...

My wagon has a Honda muffler with lifetime warranty, except that Honda doesn't have them any more. It is rusting out along several seams, not loud yet. Talked to my local parts guy, who talked to...
Forum: Members' Rides 04-16-2019, 09:10 PM
Replies: 29
Views: 3,952
Posted By fleetw00d
Only thing I did relative to ignition was pull...

Only thing I did relative to ignition was pull the wires off the plugs and pull the plugs. Didn't disturb the wires at the distributor.

Whole evening spent following the manual. Came down to a...
Forum: Members' Rides 04-15-2019, 10:31 PM
Replies: 29
Views: 3,952
Posted By fleetw00d
Had two people come and drive it, the first...

Had two people come and drive it, the first person was concerned about the vibration at idle. I changed the rear engine mount (old mount was definitely bad). That helped some, but the second person...
Forum: Beginner Appearance 04-15-2019, 06:50 AM
Replies: 2
Views: 67
Posted By fleetw00d
Front or rear bumper, or both? A lot of the...

Front or rear bumper, or both? A lot of the clips are still available from Honda. www.hondaautomotiveparts.com is a good source for part information and purchase (30% off). If you're talking about...
Forum: Suspension 04-12-2019, 09:16 PM
Replies: 4
Views: 33
Posted By fleetw00d
You'll be lucky if you can find something you can...

You'll be lucky if you can find something you can use as is. Might be better off if you find a knuckle, just take the knuckle, hub & bearing. It would be a good opportunity to go ahead and replace...
Forum: Beginner Technical/Performance 04-12-2019, 04:26 PM
Replies: 7
Views: 90
Posted By fleetw00d
Lot of information in this thread on various...

Lot of information in this thread on various wheel sizes:

http://www.cb7tuner.com/vbb/showthread.php?t=12533
Forum: Suspension 04-12-2019, 11:23 AM
Replies: 4
Views: 33
Posted By fleetw00d
They will be different between ABS and non-ABS...

They will be different between ABS and non-ABS only because there are a few tapped holes for retaining the ABS sensor lead. If you have a non-ABS car, you should be able use either one.
Forum: Beginner Technical/Performance 04-12-2019, 11:19 AM
Replies: 7
Views: 90
Posted By fleetw00d
If the original wheels are OEM aluminum, there...

If the original wheels are OEM aluminum, there are places that can refinish them. There are also 16 wheels that came on 97-99 Acura CL models that were still 4 lug.
Forum: Technical 04-11-2019, 08:26 PM
Replies: 21
Views: 214
Posted By fleetw00d
The bolt can be rotated fully; that's what I mean...

The bolt can be rotated fully; that's what I mean that regardless of which direction they turn it, they will eventually get it to where they need it. As it does, it moves the pivot point of the...
Forum: Technical 04-11-2019, 08:19 PM
Replies: 2
Views: 42
Posted By fleetw00d
The rear lower window seals Rilas mentions are...

The rear lower window seals Rilas mentions are eight clips that hold down the chrome trim at the base of the rear windshield. Each of these clips penetrates the sheet metal and has a gasket that...
Forum: Technical 04-11-2019, 11:42 AM
Replies: 21
Views: 214
Posted By fleetw00d
It depends on which way the offset washer is...

It depends on which way the offset washer is positioned to begin with. If the offset washer is centered above the bolt head, on the left side turning it CCW will increase toe; on the right side...
Forum: Technical 04-11-2019, 11:34 AM
Replies: 12
Views: 256
Posted By fleetw00d
What is the vehicle speed when it shifts? At...

What is the vehicle speed when it shifts? At what throttle position? Light, halfway, on the floor?
Forum: Technical 04-09-2019, 11:33 AM
Replies: 21
Views: 214
Posted By fleetw00d
I swapped the cross member because I knew one...

I swapped the cross member because I knew one bolt was seized and I already had another cross member and control arms in which all the bolts were free. If you can't break all four inner end bolts...
Forum: Appearance 04-08-2019, 08:03 PM
Replies: 6
Views: 121
Posted By fleetw00d
I'm always up for a road trip. I have to catch...

I'm always up for a road trip. I have to catch up to wtfisafleak (378k vs. 390k).
Forum: Technical 04-08-2019, 07:51 PM
Replies: 21
Views: 214
Posted By fleetw00d
The knuckle should just hang from the shock. ...

The knuckle should just hang from the shock. Just a lot of wrenching to swap everything over. If you drop the whole cross member and control arms together, you will probably have to drop the exhaust...
Forum: Technical 04-08-2019, 04:12 PM
Replies: 21
Views: 214
Posted By fleetw00d
Remind me, EX or LX? If EX, be careful with the...

Remind me, EX or LX? If EX, be careful with the ABS sensor wires that run in the rear lower control arm. The bolts you are most likely to have problems with are the pivot bolts for the control...
Forum: Appearance 04-08-2019, 07:48 AM
Replies: 6
Views: 121
Posted By fleetw00d
I think I have it all, problem would be packing...

I think I have it all, problem would be packing it to ship it - large boxes get expensive regardless of weight. I might have reason to go to Charlotte, NC sometime soon - Atlanta isn't too far out...
Forum: Appearance 04-07-2019, 07:44 PM
Replies: 6
Views: 121
Posted By fleetw00d
Which pieces do you need? Honda shows the clips...

Which pieces do you need? Honda shows the clips as discontinued. If you're careful, some of the clips will come out intact.

Edit: Wow. I searched all sorts of clips suppliers - didn't find this...
Forum: Technical 04-07-2019, 08:56 AM
Replies: 11
Views: 102
Posted By fleetw00d
I've only replaced one rear main; at the time, I...

I've only replaced one rear main; at the time, I bought the seal already installed in the plate. It's just that the OEM service manual is very specific about how deep in the plate it is supposed to...
Forum: Technical 04-06-2019, 08:28 PM
Replies: 11
Views: 102
Posted By fleetw00d
There are a few seal plates available on ebay...

There are a few seal plates available on ebay (plate with seal is no longer available from Honda); you could get one and carefully change the seal in that. Down side is that replacing the plate...
Forum: Technical 04-06-2019, 02:33 PM
Replies: 11
Views: 102
Posted By fleetw00d
I wouldn't think the throw out bearing would have...

I wouldn't think the throw out bearing would have prevented the clutch from working. It wouldn't engage, or disengage? If the friction disk were worn out, the car wouldn't move. If the clutch...
Forum: Other Automotive Members Rides 04-05-2019, 10:20 PM
Replies: 12
Views: 1,465
Posted By fleetw00d
Door locks started acting up on this. Symptoms...

Door locks started acting up on this. Symptoms pointed to the driver door latch/lock assembly. Replaced that this evening. Only problem was I kept dropping the clip for the lock cable into the...
Forum: Technical 04-05-2019, 10:14 PM
Replies: 11
Views: 102
Posted By fleetw00d
Remind me, your clutch doesn't have a lot of mile...

Remind me, your clutch doesn't have a lot of mile on it correct? Was the flywheel changed or refinished when that clutch was installed?
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -5. The time now is 05:33 AM.


Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.