CB7Tuner Forums

Go Back   CB7Tuner Forums > Search Forums

Showing results 1 to 25 of 500
Search took 1.15 seconds.
Search: Posts Made By: deevergote
Forum: Beginner Technical/Performance Yesterday, 03:33 PM
Replies: 10
Views: 62
Posted By deevergote
It’s basically an LX with “extras”. Rear disc...

It’s basically an LX with “extras”. Rear disc brakes were one of those extras. :D

It’s somewhere between LX and EX, basically. It has the LX/DX engine and roof. EX alloys and brakes. And painted...
Forum: Beginner Technical/Performance Yesterday, 11:49 AM
Replies: 10
Views: 62
Posted By deevergote
I THINK it’s back to the ECU. Check the pinout...

I THINK it’s back to the ECU. Check the pinout and how your A1 plug is wired.
I had a shop swap out my A1 for an H22 before I knew very much. Learned years later that my IAB setup was done wrong,...
Forum: Beginner Technical/Performance Yesterday, 05:52 AM
Replies: 10
Views: 62
Posted By deevergote
You’ll need an auto PT6 ECU (A6 ECU). As for the...

You’ll need an auto PT6 ECU (A6 ECU).
As for the wiring, you can simply add the necessary wires for the IAB system. Everything else should work from your A1 setup.
Forum: Beginner Appearance 06-16-2019, 06:38 PM
Replies: 4
Views: 298
Posted By deevergote
That list encompasses all of the lips everyone...

That list encompasses all of the lips everyone knows will fit because someone tried. To my knowledge, nobody has tried a Civic lip (or at least nobody has reported successfully mounting one.) It...
Forum: Suspension 06-04-2019, 10:18 AM
Replies: 57
Views: 3,914
Posted By deevergote
:tu: Thanks for addressing it, John. It means a...

:tu:
Thanks for addressing it, John. It means a lot when feedback is taken seriously so improvements can be made!
Forum: Suspension 05-31-2019, 07:37 AM
Replies: 57
Views: 3,914
Posted By deevergote
It’s the actual tip of the oem arm that rubs (or...

It’s the actual tip of the oem arm that rubs (or the adjustable ball joint added to it, if that’s the camber correction option utilized). A kit that maintains the width of the oem arm would have the...
Forum: Suspension 05-29-2019, 06:20 PM
Replies: 57
Views: 3,914
Posted By deevergote
Ah, ok. I see what you mean. They’re wider at the...

Ah, ok. I see what you mean. They’re wider at the point where the ball joint sits, correct? I can see how that would cause issues.
Forum: Suspension 05-29-2019, 10:01 AM
Replies: 57
Views: 3,914
Posted By deevergote
There is absolutely no way to fully correct...

There is absolutely no way to fully correct camber when lowered beyond a certain point without adding clearance. It is a matter of geometry, not poor design on ESP’s part. The upper ball joint must...
Forum: Beginner "Off Topic" 05-21-2019, 08:25 PM
Replies: 10
Views: 259
Posted By deevergote
You can gauge interest by the 3rd generation,...

You can gauge interest by the 3rd generation, somewhat. The following decreases, but as long as a handful of quality parts makers exist, the ability to build an impressive car will remain. The CB has...
Forum: Off Topic 05-21-2019, 07:37 PM
Replies: 28
Views: 532
Posted By deevergote
Black on black on black on black. Beautiful! Audi...

Black on black on black on black. Beautiful! Audi has some of the very best designs, and they age extremely well. That thing will look like a new car for a decade!
2017, so I assume you still have...
Forum: Beginner Technical/Performance 05-19-2019, 10:46 PM
Replies: 12
Views: 294
Posted By deevergote
Hopefully that’s the fix! Keep us updated!

Hopefully that’s the fix! Keep us updated!
Forum: Beginner Technical/Performance 05-18-2019, 04:05 PM
Replies: 3
Views: 103
Posted By deevergote
Have you pulled the code? You should be able to...

Have you pulled the code? You should be able to find a blue plug under your dash on the passenger side. It won’t be plugged into anything. Jump the two holes with a wire or metal paperclip, turn your...
Forum: Off Topic 05-10-2019, 12:28 PM
Replies: 7
Views: 227
Posted By deevergote
Good ones will hold some value once they become...

Good ones will hold some value once they become scarce enough. Supply and demand. If the demand of a handful of enthusiasts exceeds the supply of worthwhile CBs, the few remaining worthwhile cars...
Forum: Off Topic 05-09-2019, 08:31 AM
Replies: 7
Views: 227
Posted By deevergote
Early on, I liked that the CB was the “ignored...

Early on, I liked that the CB was the “ignored accord”. It made it special. Everyone wanted Civics, and the CB offered hidden potential! But now, it really does get glossed over. There was no R...
Forum: Beginner Technical/Performance 05-07-2019, 08:46 PM
Replies: 9
Views: 153
Posted By deevergote
Are the camshafts and gears factory original? Is...

Are the camshafts and gears factory original? Is there any indication of damage or alteration? If the cams or gears are somehow wrong, you could be lining up all the marks and the timing would be off.
Forum: Beginner Technical/Performance 05-07-2019, 08:44 PM
Replies: 9
Views: 153
Posted By deevergote
The o2 sensor only matters once the engine is at...

The o2 sensor only matters once the engine is at operating temperature. When the ECU is in open loop mode, it’s fueling based on the fuel map, not sensor feedback.
If it’s giving problems at cold...
Forum: Beginner Technical/Performance 05-07-2019, 06:52 PM
Replies: 9
Views: 153
Posted By deevergote
A CEL can definitely put it in limp mode, though...

A CEL can definitely put it in limp mode, though that shouldn’t keep it from idling.

Have you done a compression test? Checked to make sure all injectors are working (and working correctly)? How do...
Forum: Off Topic 04-29-2019, 07:56 AM
Replies: 33
Views: 955
Posted By deevergote
I’m finally back on a PC after a year of being...

I’m finally back on a PC after a year of being stuck only with my phone, so that’ll help speed things along as well!
Forum: Off Topic 04-28-2019, 09:33 PM
Replies: 33
Views: 955
Posted By deevergote
Waiting for Pandemic to pull a verified complete...

Waiting for Pandemic to pull a verified complete backup, in case things break. Changing the post requirement will change the status of thousands of members, and there’s a chance it could corrupt the...
Forum: Beginner "Off Topic" 04-28-2019, 09:31 PM
Replies: 43
Views: 16,329
Posted By deevergote
You’ll always have access. Once you pass 30...

You’ll always have access. Once you pass 30 posts, you just can’t create new threads in this section. You can always reply to threads here, though.
You can also ask for it to be moved, if you’d...
Forum: Beginner Technical/Performance 04-28-2019, 11:44 AM
Replies: 12
Views: 294
Posted By deevergote
You’re the man, Mike! I was looking to see if I...

You’re the man, Mike!
I was looking to see if I could find non-US diagrams, and I had no luck!
Forum: Beginner Technical/Performance 04-28-2019, 10:26 AM
Replies: 12
Views: 294
Posted By deevergote
What does your module look like? Your parts may...

What does your module look like? Your parts may differ from US spec, but the module should be located under the indicated area in the picture. You shouldn’t need to remove that part. There should be...
Forum: Beginner Technical/Performance 04-24-2019, 06:47 PM
Replies: 17
Views: 329
Posted By deevergote
Absolutely. And honestly, unless the car is...

Absolutely. And honestly, unless the car is seeing serious track duty, there’s very little need to upgrade brakes any further than quality rotors and more aggressive pads.

Wheel options are...
Forum: Beginner Technical/Performance 04-20-2019, 01:24 PM
Replies: 4
Views: 104
Posted By deevergote
I’m not sure of the exact placement on a RHD...

I’m not sure of the exact placement on a RHD vehicle, but it should be somewhere under the dash next to your steering column. If it’s a mirror of a LHD car, it’ll likely be on the left side. On...
Forum: Beginner Technical/Performance 04-19-2019, 07:57 PM
Replies: 3
Views: 131
Posted By deevergote
Yeah, that’s another very good near-stock option.

Yeah, that’s another very good near-stock option.
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -5. The time now is 05:53 PM.


Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.