CB7Tuner Forums

Go Back   CB7Tuner Forums > Search Forums

Showing results 1 to 25 of 500
Search took 0.06 seconds.
Search: Posts Made By: Ghetto_CB7
Forum: Video Clips 09-23-2012, 03:42 PM
Replies: 29
Views: 4,690
Posted By Ghetto_CB7
sure. I told the op he would make more power on...

sure.

I told the op he would make more power on his current setup with tuners, I didn't say sell your pro1's.

I still maintain this is true. every person with those cams making power on "stock...
Forum: Video Clips 09-23-2012, 01:26 PM
Replies: 29
Views: 4,690
Posted By Ghetto_CB7
quite possible that flat faced valves and milled...

quite possible that flat faced valves and milled head would have the 250hp guy around 11.5:1.

which is 2 points above the op's.

I still wouldn't do it on stock compression and I'm willing to bet...
Forum: Video Clips 09-23-2012, 04:00 AM
Replies: 29
Views: 4,690
Posted By Ghetto_CB7
post the link...

post the link...
Forum: Video Clips 09-23-2012, 12:32 AM
Replies: 29
Views: 4,690
Posted By Ghetto_CB7
stock compression is sufficient for pro 3 too if...

stock compression is sufficient for pro 3 too if you just want to make your car less streatable and not gain a hole lot of anything.

You would gain power by dropping to a tuner cam with your current...
Forum: Beginner Technical/Performance 09-22-2012, 03:59 PM
Replies: 26
Views: 874
Posted By Ghetto_CB7
also for the wire to pop off probably means you...

also for the wire to pop off probably means you are running non honda or non ngk wires.

I never recommend this.

Even 20 year old junk yard wires are better and more reliable then bosch premium...
Forum: Beginner Technical/Performance 09-22-2012, 03:56 PM
Replies: 26
Views: 874
Posted By Ghetto_CB7
Yes why spend 10$ to make sure it is done...

Yes why spend 10$ to make sure it is done right.

You do not want to over torque your spark plugs.

Go to the store and buy some ngk, then use a properly calibrated torque wrench to torque them to...
Forum: Beginner Technical/Performance 09-22-2012, 01:31 PM
Replies: 8
Views: 935
Posted By Ghetto_CB7
more then ring. For zero compression you would...

more then ring.

For zero compression you would be looking at more then bad rings, you have issues there.

Get a leakdown test, or if it is that bad, remove valve cover and rotate engine by hand...
Forum: Video Clips 09-22-2012, 03:01 AM
Replies: 29
Views: 4,690
Posted By Ghetto_CB7
This is not true, it depends on engagement rpm...

This is not true, it depends on engagement rpm exhaust engine mods, including cams, basically everything engine related.

Here is an h22 engaging vtec at about 4000...
Forum: Racing 09-22-2012, 02:57 AM
Replies: 13
Views: 1,375
Posted By Ghetto_CB7
?

I don't know what you are talking about.
Forum: Racing 09-21-2012, 12:37 PM
Replies: 13
Views: 1,375
Posted By Ghetto_CB7
16 miles bottom to top and 150 corners. This...

16 miles bottom to top and 150 corners.

This road is pure sex.

Also you shouldn't be street racing :angry: :thumbsdwn :wavey:
Forum: Video Clips 09-21-2012, 12:32 PM
Replies: 29
Views: 4,690
Posted By Ghetto_CB7
I has a question

Did you degree your cams?

Also you NEEEED more compression for the pro1 I am hoping a block build is in your near future.
Forum: Technical 09-21-2012, 12:23 PM
Replies: 1
Views: 296
Posted By Ghetto_CB7
Have you done anything new to the vehicle...

Have you done anything new to the vehicle recently?

If not you can start by removing the FITV (if you are running one) and making sure the white plastic screw is completely tight.

If you know...
Forum: Suspension 09-20-2012, 01:36 PM
Replies: 22
Views: 1,263
Posted By Ghetto_CB7
SPC VS Ingalls

I have had both of these ball joint kits, and I can tell you that IMO the SPC kit is significantly higher quality than the ingalls.

I have no experience with the anchor bolt kits though.

Also it...
Forum: Naturally Aspirated 09-20-2012, 02:00 AM
Replies: 222
Views: 44,830
Posted By Ghetto_CB7
my last post was 9 minutes ago

my last post was 9 minutes ago
Forum: Naturally Aspirated 09-20-2012, 01:50 AM
Replies: 222
Views: 44,830
Posted By Ghetto_CB7
Rules state that car must be running, it says...

Rules state that car must be running, it says nothing about still making the same power.

For those that don't know I over revved a downshift on a mountain run a few months back and bent some...
Forum: Naturally Aspirated 09-19-2012, 07:44 PM
Replies: 222
Views: 44,830
Posted By Ghetto_CB7
Engine: F22a1 (211000...

Engine: F22a1 (211000 Miles)

Modifications:

Bolt Ons:
-----Ebay Short Ram Intake

Internals:
-----Stock
Forum: Naturally Aspirated 03-12-2012, 02:49 PM
Replies: 225
Views: 29,412
Posted By Ghetto_CB7
TB and injectors

The RDX injectors are nice, and with some added fuel pressure can flow above 500CC You do need a different fuel rail, and it is recommended that you have the manifold side cut too since the spray...
Forum: Beginner "Off Topic" 02-01-2012, 01:45 AM
Replies: 41
Views: 2,636
Posted By Ghetto_CB7
blah

I believe...

Duck tape was originally created for the military to prevent important things from getting wet. It was aptly named duck tape because of the way water runs off of it like water off of a...
Forum: Beginner Technical/Performance 01-31-2012, 11:10 PM
Replies: 12
Views: 1,069
Posted By Ghetto_CB7
But the car was still accelerating until it...

But the car was still accelerating until it turned off by itself. Shouldn't do that in neutral, sounds like something was still engaged to me...
Forum: Beginner "Off Topic" 01-31-2012, 10:58 PM
Replies: 41
Views: 2,636
Posted By Ghetto_CB7
what i got censored

Lol didn't know you could get censored, Han I say homosexual?

Guess I will find out.
Forum: Beginner "Off Topic" 01-31-2012, 10:40 PM
Replies: 41
Views: 2,636
Posted By Ghetto_CB7
yup

I own gray, black, and then last year me and my buddies bought our *** friend a hot pink roll.
Forum: Beginner "Off Topic" 01-31-2012, 10:35 PM
Replies: 41
Views: 2,636
Posted By Ghetto_CB7
duck vs duct...

duck vs duct (http://www.octanecreative.com/ducttape/duckvsduct.html)
Forum: Beginner "Off Topic" 01-31-2012, 10:33 PM
Replies: 41
Views: 2,636
Posted By Ghetto_CB7
I am hence forth reffering to you as Pam. I also...

I am hence forth reffering to you as Pam.

I also do not ever remember seeing a post by you, deev you should make sure he hasent hacked his post count!

Or maybe its a conspiracy, deev are you taking...
Forum: Beginner "Off Topic" 01-31-2012, 10:27 PM
Replies: 41
Views: 2,636
Posted By Ghetto_CB7
who the hell id evan?

The actual quote is...

If you can't fix it with duck tape, bailing wire and wood screws it ain't worth fixing.

And on a more important note, who the hell doesn't own duck tape. It is an essential...
Forum: Beginner Technical/Performance 01-30-2012, 11:40 AM
Replies: 12
Views: 1,069
Posted By Ghetto_CB7
The car should not accelerate when in neutral. ...

The car should not accelerate when in neutral. If it did you have transmission issues.

The engine can rev higher, but you should not accelerate in neutral.

Lets us know if you meant something...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -5. The time now is 04:09 AM.


Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.