CB7Tuner Forums

Go Back   CB7Tuner Forums > Search Forums

Showing results 1 to 17 of 17
Search took 0.01 seconds.
Search: Posts Made By: Ashtrain
Forum: Beginner Audio/Electronics 01-21-2019, 10:17 AM
Replies: 3
Views: 251
Posted By Ashtrain
If im understanding your description properly....

If im understanding your description properly. you swapped entire door, cut the wiring harness between door and body, spliced wires together, no internal door parts\connections were swapped? If...
Forum: Beginner Technical/Performance 01-21-2019, 08:27 AM
Replies: 21
Views: 1,690
Posted By Ashtrain
a 12volt power distribution wire that is showing...

a 12volt power distribution wire that is showing low voltage at the fuse panel output and the 12volt input is ok, 100% the problem is at the fuse box, if not internally burnt,there is a loose...
Forum: Beginner Image Gallery 01-21-2019, 04:07 AM
Replies: 1
Views: 204
Posted By Ashtrain
https://i.imgur.com/WGEefUs.jpg https://i.imgur.co...

https://i.imgur.com/WGEefUs.jpg
https://i.imgur.com/pbikF3w.jpg
https://i.imgur.com/2nSl7K5.jpg
https://i.imgur.com/CeOriXY.jpg
https://i.imgur.com/P67VdkP.jpg
Forum: Beginner Image Gallery 01-21-2019, 02:33 AM
Replies: 1
Views: 204
Posted By Ashtrain
93 lx random build pics (trying to figure out uploading pictures)

https://i.imgur.com/Q7GEKwd.jpg
https://i.imgur.com/HElhtTB.jpg
https://i.imgur.com/D8Azu95.jpg
https://i.imgur.com/Uuf0XFJ.jpg
Forum: Beginner Technical/Performance 01-21-2019, 01:14 AM
Replies: 22
Views: 1,319
Posted By Ashtrain
did you ever get this sorted out? If not, I would...

did you ever get this sorted out? If not, I would look at the ignition control module inside the distributor, even if its been replaced already with new distributor, if there was a big temperature...
Forum: Beginner Technical/Performance 01-20-2019, 11:53 PM
Replies: 8
Views: 2,690
Posted By Ashtrain
the relay is located under left side of...

the relay is located under left side of dash,below and left of main relay, yellow connector,wire colors are wht/yel, blu/red, LTgrn/blu and black. the SRS system and horn share the same power12v...
Forum: Beginner Technical/Performance 05-28-2018, 02:59 PM
Replies: 21
Views: 1,690
Posted By Ashtrain
<object id="pdfOb"...

<object id="pdfOb"...
Forum: Beginner Technical/Performance 05-26-2018, 07:52 AM
Replies: 13
Views: 1,394
Posted By Ashtrain
Use some brake cleaner or carburetor cleaner etc,...

Use some brake cleaner or carburetor cleaner etc, spray around intake and all vacuum hoses with the engine running, if there is a noticeable change in rpm when spraying a certain spot there is your...
Forum: Beginner Technical/Performance 05-03-2018, 03:49 PM
Replies: 21
Views: 1,690
Posted By Ashtrain
Sorry I misread that, 6.6 volts at fuse 1 is...

Sorry I misread that, 6.6 volts at fuse 1 is definitely a problem inside the fuse panel if you have no other issues with indicators in the cluster,power for fuse #1 goes through fuses #4,5a and 6...
Forum: Beginner Technical/Performance 05-03-2018, 03:36 PM
Replies: 21
Views: 1,690
Posted By Ashtrain
Sorry for the delay, my next suggestion is a real...

Sorry for the delay, my next suggestion is a real pain to get to but itís the fastest way we can figured out where itís losing voltage, access the back of the dash fuse panel, it has to be unbolted...
Forum: Beginner Technical/Performance 04-19-2018, 11:50 AM
Replies: 21
Views: 1,690
Posted By Ashtrain
The speed sensor has 3 wires, there should be...

The speed sensor has 3 wires, there should be battery voltage on the yellow wire with the key in the run or start position, the orange wire is the signal output, it should have a 12 volt square wave...
Forum: Beginner Technical/Performance 03-31-2018, 06:29 PM
Replies: 18
Views: 884
Posted By Ashtrain
In the start position the Ignition switch black/...

In the start position the Ignition switch black/ white wire sends battery voltage to the under dash fuse panel, from there it travels to the neutral position switch/ gear selector switch then out to...
Forum: Beginner Technical/Performance 03-29-2018, 11:51 AM
Replies: 18
Views: 1,010
Posted By Ashtrain
Verify that the white/green wire is not grounded,...

Verify that the white/green wire is not grounded, the ecu can disable the charging system by grounding this wire,
1. To test the system, verify the Black/Yellow wire at the alternator has battery...
Forum: Beginner Technical/Performance 03-26-2018, 05:33 AM
Replies: 18
Views: 1,010
Posted By Ashtrain
http://s1149.photobucket.com/user/Ashtrain/library...

http://s1149.photobucket.com/user/Ashtrain/library/Cb7?sort=3&page=1#
Hopefully these can be viewed if not I'll try again, these are just a few, if you want something specific let me know which...
Forum: Beginner Technical/Performance 03-26-2018, 12:46 AM
Replies: 18
Views: 1,010
Posted By Ashtrain
https://www.hondaaccordforum.com/forum/audio-visua...

https://www.hondaaccordforum.com/forum/audio-visual-electronics-10/honda-electrical-load-detection-eld-bypass-32726/
This is what got me started as far as ELD is concerned, you can change resistor...
Forum: Beginner Technical/Performance 03-26-2018, 12:24 AM
Replies: 18
Views: 1,010
Posted By Ashtrain
The alternator circuit in hondas is very...

The alternator circuit in hondas is very misleading, the ELD has direct control over alternator output voltage, high load=high voltage, low load=low voltage, a Honda charging circuit can show 12.9...
Forum: Beginner "Off Topic" 03-15-2018, 05:37 AM
Replies: 3
Views: 310
Posted By Ashtrain
First post just saying hello

How's it going cb7 community, old/new member (never posted under other name years ago),I'm so glad too see this site still around, anyway it's been great spending the last 24 hours or so reading and...
Showing results 1 to 17 of 17

 
Forum Jump

All times are GMT -5. The time now is 03:03 AM.


Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.