CB7Tuner Forums

Go Back   CB7Tuner Forums > Search Forums

Showing results 1 to 25 of 500
Search took 2.12 seconds.
Search: Posts Made By: GhostAccord
Forum: Members' Rides 08-21-2019, 10:19 PM
Replies: 2,551
Views: 351,473
Posted By GhostAccord
lol.... all good! :tu: Very common mix up.

lol.... all good! :tu: Very common mix up.
Forum: Members' Rides 08-21-2019, 01:26 PM
Replies: 2,551
Views: 351,473
Posted By GhostAccord
I think you probably few into St. John's...

I think you probably few into St. John's Newfoundland. The winters here in Saint John, New Brunswick, a little bit further south west, aren't quite as bad. We still live in shanties and igloos...
Forum: Members' Rides 08-21-2019, 11:19 AM
Replies: 2,551
Views: 351,473
Posted By GhostAccord
Yes, Saint John NB to be exact. I don't get to NS...

Yes, Saint John NB to be exact. I don't get to NS very often. We usually head west or if we head east it's to PEI.

Earlier this year I was thinking about hitting the dyno @ Raven Autoports to tune...
Forum: Members' Rides 08-21-2019, 10:53 AM
Replies: 2,551
Views: 351,473
Posted By GhostAccord
Low impedance are actually a much more accurate...

Low impedance are actually a much more accurate injector when used with a proper driver circuit. However, as the tuner stated, they are older and there are more items that may fail, the resistor box...
Forum: Off Topic 07-16-2019, 01:21 PM
Replies: 4,180
Views: 386,643
Posted By GhostAccord
My 85 GT has the same VIN code 9 (high Output),...

My 85 GT has the same VIN code 9 (high Output), L44 V6 as the X-11.
140 hp @ 5200 rpm
170 lb⋅ft @ 3600 rpm
Forum: Off Topic 07-16-2019, 09:01 AM
Replies: 4,180
Views: 386,643
Posted By GhostAccord
Yes sir, it is the GT V6 4speed. All original...

Yes sir, it is the GT V6 4speed. All original 98,000km. The Suspension and clutch components are a bit week. Going to need a little refreshing, but it's not bad for being 34 years old.

There aren't...
Forum: Off Topic 07-16-2019, 05:52 AM
Replies: 4,180
Views: 386,643
Posted By GhostAccord
Had to buy something small and fun that runs, not...

Had to buy something small and fun that runs, not another...
Forum: Beginner Technical/Performance 04-12-2019, 02:16 PM
Replies: 6
Views: 235
Posted By GhostAccord
Ditch the OBD2 IMMO ECU and ether go with a 94-95...

Ditch the OBD2 IMMO ECU and ether go with a 94-95 Accord VTEC OBD1 ECU (37820-P0A-XXX). Or opt for an OBD1 chipped and tuned ECU.
Forum: Off Topic 04-06-2019, 08:10 AM
Replies: 4,180
Views: 386,643
Posted By GhostAccord
The blogs get up and go, kind of got up and went...

The blogs get up and go, kind of got up and went after the whole photobucket shyte.

Winter is a tough one for me to get any work done on vehicles. During the winter months my garage is no longer a...
Forum: Off Topic 04-05-2019, 02:57 PM
Replies: 4,180
Views: 386,643
Posted By GhostAccord
Something to build on a rainy day. Looks very...

Something to build on a rainy day. Looks very similar to mine! I hadn't planed to go with this paint scheme....... but that being said.......
Forum: ECU Tuning 03-08-2019, 11:20 AM
Replies: 6
Views: 730
Posted By GhostAccord
Are you looking for a Crome *.bin file? If you...

Are you looking for a Crome *.bin file?

If you are, I can take a few minutes and see if I can find something in my database of bin files. I know that I have tuned a few chipped and modified P06 and...
Forum: Beginner Technical/Performance 02-18-2019, 10:51 AM
Replies: 3
Views: 238
Posted By GhostAccord
If you are looking to go forced induction in the...

If you are looking to go forced induction in the end, stick with the F23, with very little work it can perform just as well, if not more reliably, as any of the DOHC engines with a lot less work.
Forum: Off Topic 12-26-2018, 01:25 PM
Replies: 9
Views: 404
Posted By GhostAccord
Merry Christmas and a Happy New Year to...

Merry Christmas and a Happy New Year to all

Cheers!
Forum: Beginner Technical/Performance 11-17-2018, 10:24 PM
Replies: 6
Views: 425
Posted By GhostAccord
Check your fuses and all the ground and power...

Check your fuses and all the ground and power connections to and from the battery. Check to see that when you pulled the wires/connections off the battery that you didn't inadvertently disconnect a...
Forum: Beginner Technical/Performance 11-17-2018, 02:51 AM
Replies: 6
Views: 425
Posted By GhostAccord
If you have no power anywhere, it's more than...

If you have no power anywhere, it's more than likely the battery. Have you tried charging it? You could have it load tested at a local parts store.

The alternator does not supply cranking/starting...
Forum: Other Automotive Members Rides 10-10-2018, 02:53 PM
Replies: 68
Views: 8,763
Posted By GhostAccord
Christmas came early this...

Christmas came early this...
Forum: Beginner Technical/Performance 10-08-2018, 11:19 PM
Replies: 7
Views: 404
Posted By GhostAccord
The OP is correct, all F22A and F22B intake...

The OP is correct, all F22A and F22B intake manifolds are two piece, upper plenum and lower runners. That being said the A1-A4 have a single set of runners vs the F20B, H22 & H23 dual runners with an...
Forum: Beginner "Off Topic" 09-23-2018, 04:52 AM
Replies: 3
Views: 483
Posted By GhostAccord
Don't bother with the following items -AEM high...

Don't bother with the following items

-AEM high volume fuel rail $112 - OEM rail will flow more than enough, even to feed 550cc injectors.

-Spectra premium fuel pump $25 - If the one you have works...
Forum: Beginner Technical/Performance 09-16-2018, 09:34 PM
Replies: 8
Views: 408
Posted By GhostAccord
You could very well be correct. My 96 F22B2 had...

You could very well be correct. My 96 F22B2 had one. Just thought I would give you a heads up that there is an issue with the seals and if your engine doesn't have one, there is a retainer available....
Forum: Beginner Technical/Performance 09-16-2018, 07:52 PM
Replies: 8
Views: 408
Posted By GhostAccord
Something else to look at would be the balance...

Something else to look at would be the balance shaft oil seal retainer. If your engine does not have it, now would also be a good time to add that cheap...
Forum: Beginner Technical/Performance 09-15-2018, 09:39 PM
Replies: 8
Views: 408
Posted By GhostAccord
Yes you will want to do the belt, tensioner and...

Yes you will want to do the belt, tensioner and valve adjustment. Also a good time to do the water pump if it hasn't been done.
Forum: Technical 09-15-2018, 01:33 AM
Replies: 4
Views: 224
Posted By GhostAccord
The head bolts can be reused. I have reused the...

The head bolts can be reused. I have reused the head bolts once or twice with no issues. I don't see it being an issue for a quick test to reuse the head gasket.
Forum: Technical 09-10-2018, 12:37 PM
Replies: 6
Views: 365
Posted By GhostAccord
Lack of oil, heat binding the cam to the journals...

Lack of oil, heat binding the cam to the journals then the pistons coming into contact with the other 2-3 cylinders valves???? have to remove the head and see what the valves and piston tops look...
Forum: Off Topic 09-04-2018, 08:34 AM
Replies: 8
Views: 750
Posted By GhostAccord
I think this might be your guy....

I think this might be your guy.

https://www.facebook.com/Fasn8u007?lst=901150359%3A100004211059200%3A1536067380

Couple videos he has on prelude nation. He stresses that he did his 5 speed swap the...
Forum: Off Topic 09-04-2018, 08:05 AM
Replies: 8
Views: 750
Posted By GhostAccord
That is a troll, internet car builder. Probably...

That is a troll, internet car builder. Probably never turned a rench on anything more than bolt on exhaust and has one of those DIY PVC pipe through the headlight legit CAI.....lol

I would feed him...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -5. The time now is 07:01 PM.


Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.