CB7Tuner Forums

Go Back   CB7Tuner Forums > Search Forums

Showing results 1 to 25 of 500
Search took 0.36 seconds.
Search: Posts Made By: GhostAccord
Forum: Beginner Technical/Performance 11-17-2018, 11:24 PM
Replies: 6
Views: 198
Posted By GhostAccord
Check your fuses and all the ground and power...

Check your fuses and all the ground and power connections to and from the battery. Check to see that when you pulled the wires/connections off the battery that you didn't inadvertently disconnect a...
Forum: Beginner Technical/Performance 11-17-2018, 03:51 AM
Replies: 6
Views: 198
Posted By GhostAccord
If you have no power anywhere, it's more than...

If you have no power anywhere, it's more than likely the battery. Have you tried charging it? You could have it load tested at a local parts store.

The alternator does not supply cranking/starting...
Forum: Other Automotive Members Rides 10-10-2018, 03:53 PM
Replies: 68
Views: 7,412
Posted By GhostAccord
Christmas came early this...

Christmas came early this...
Forum: Beginner Technical/Performance 10-09-2018, 12:19 AM
Replies: 7
Views: 237
Posted By GhostAccord
The OP is correct, all F22A and F22B intake...

The OP is correct, all F22A and F22B intake manifolds are two piece, upper plenum and lower runners. That being said the A1-A4 have a single set of runners vs the F20B, H22 & H23 dual runners with an...
Forum: Beginner "Off Topic" 09-23-2018, 05:52 AM
Replies: 3
Views: 255
Posted By GhostAccord
Don't bother with the following items -AEM high...

Don't bother with the following items

-AEM high volume fuel rail $112 - OEM rail will flow more than enough, even to feed 550cc injectors.

-Spectra premium fuel pump $25 - If the one you have works...
Forum: Beginner Technical/Performance 09-16-2018, 10:34 PM
Replies: 8
Views: 213
Posted By GhostAccord
You could very well be correct. My 96 F22B2 had...

You could very well be correct. My 96 F22B2 had one. Just thought I would give you a heads up that there is an issue with the seals and if your engine doesn't have one, there is a retainer available....
Forum: Beginner Technical/Performance 09-16-2018, 08:52 PM
Replies: 8
Views: 213
Posted By GhostAccord
Something else to look at would be the balance...

Something else to look at would be the balance shaft oil seal retainer. If your engine does not have it, now would also be a good time to add that cheap...
Forum: Beginner Technical/Performance 09-15-2018, 10:39 PM
Replies: 8
Views: 213
Posted By GhostAccord
Yes you will want to do the belt, tensioner and...

Yes you will want to do the belt, tensioner and valve adjustment. Also a good time to do the water pump if it hasn't been done.
Forum: Technical 09-15-2018, 02:33 AM
Replies: 4
Views: 108
Posted By GhostAccord
The head bolts can be reused. I have reused the...

The head bolts can be reused. I have reused the head bolts once or twice with no issues. I don't see it being an issue for a quick test to reuse the head gasket.
Forum: Technical 09-10-2018, 01:37 PM
Replies: 6
Views: 205
Posted By GhostAccord
Lack of oil, heat binding the cam to the journals...

Lack of oil, heat binding the cam to the journals then the pistons coming into contact with the other 2-3 cylinders valves???? have to remove the head and see what the valves and piston tops look...
Forum: Off Topic 09-04-2018, 09:34 AM
Replies: 8
Views: 480
Posted By GhostAccord
I think this might be your guy....

I think this might be your guy.

https://www.facebook.com/Fasn8u007?lst=901150359%3A100004211059200%3A1536067380

Couple videos he has on prelude nation. He stresses that he did his 5 speed swap the...
Forum: Off Topic 09-04-2018, 09:05 AM
Replies: 8
Views: 480
Posted By GhostAccord
That is a troll, internet car builder. Probably...

That is a troll, internet car builder. Probably never turned a rench on anything more than bolt on exhaust and has one of those DIY PVC pipe through the headlight legit CAI.....lol

I would feed him...
Forum: Beginner Technical/Performance 09-02-2018, 02:58 PM
Replies: 8
Views: 309
Posted By GhostAccord
As far as I know the 97 Accord, Odyssey and H23...

As far as I know the 97 Accord, Odyssey and H23 Prelude were the last to use low impedance 240cc injectors. The early F23 might have as well????

Here is a good article on what the differences...
Forum: Beginner Technical/Performance 09-02-2018, 08:48 AM
Replies: 8
Views: 309
Posted By GhostAccord
Low impedance, peak and hold requires a resistor...

Low impedance, peak and hold requires a resistor box. They are available in both OBD1 and OBD2.
High impedance, saturated, do not require a resistor box. They also come in both OBD1 and...
Forum: Members' Rides 09-02-2018, 07:48 AM
Replies: 2,382
Views: 309,889
Posted By GhostAccord
First startup is always vid worthy.... I'm hoping...

First startup is always vid worthy.... I'm hoping for a good startup and not the gone viral bad startup. ;)
Forum: Swaps 08-12-2018, 09:45 AM
Replies: 3
Views: 361
Posted By GhostAccord
If you have the F22A6 I would run that. I'm...

If you have the F22A6 I would run that. I'm pretty sure the F23 manifold is not a direct bolt on for the F22A head and it would require an adapter plate to function properly.
Forum: Beginner Technical/Performance 08-11-2018, 10:44 AM
Replies: 9
Views: 330
Posted By GhostAccord
The CKP sensor will usually throw a code if it is...

The CKP sensor will usually throw a code if it is inoperable.

Did the new distributor come with a new coil and ICM/ignitor? I had this exact issue and it turned out to be the ICM/ignitor inside the...
Forum: Beginner Technical/Performance 08-11-2018, 10:35 AM
Replies: 9
Views: 330
Posted By GhostAccord
check all of your grounds, make sure they are...

check all of your grounds, make sure they are clean and tight.
Forum: Members' Rides 07-28-2018, 01:41 PM
Replies: 2,382
Views: 309,889
Posted By GhostAccord
I am very jealous...... ;)

I am very jealous...... ;)
Forum: Technical 07-26-2018, 08:37 PM
Replies: 18
Views: 319
Posted By GhostAccord
I have used copper never seize in the past and it...

I have used copper never seize in the past and it has worked. Thing about buying a tube/tub of copper never seize is that you can use it on everything.

If that doesn't work, permatex copper should...
Forum: Off Topic 07-13-2018, 02:16 PM
Replies: 43
Views: 1,009
Posted By GhostAccord
Yeah.....I think it is very selective. I think...

Yeah.....I think it is very selective. I think she only pays attention when I am spending money on my cars. When we talk about family mattes or stuff around the house..... she doesn't remember...
Forum: Off Topic 07-13-2018, 12:13 PM
Replies: 43
Views: 1,009
Posted By GhostAccord
I recorded it last night... My wife saw his name...

I recorded it last night... My wife saw his name and right away said, isn't that where you got your camshafts from? And here I thought she was never paying attention...lol

I have purchased a few...
Forum: Members' Rides 07-07-2018, 09:31 AM
Replies: 2,382
Views: 309,889
Posted By GhostAccord
Everything is looking good, as usual. As far as...

Everything is looking good, as usual.

As far as finding power steering hose, have you tried any of your local machine/hydraulic shops, transport truck garage or farm tractor supply shops? They...
Forum: Other Automotive Members Rides 06-28-2018, 11:53 AM
Replies: 62
Views: 8,170
Posted By GhostAccord
Looks nice. I have been noticing that there are...

Looks nice.

I have been noticing that there are a lot of these starting to pop up for sale around me for reasonable prices. Still not sure one would be a fit for me. I really like the new...
Forum: Beginner Technical/Performance 06-19-2018, 05:17 PM
Replies: 185
Views: 33,088
Posted By GhostAccord
Honda manual states that it should read...

Honda manual states that it should read "approximately" 0.5v at closed throttle and 4.5v at wide open throttle. You are good with the voltage readings that you have listed.
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -5. The time now is 07:29 PM.


Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.