If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
So my engine bay was looking pretty bad, so I decided to pull out the sand paper and try to make it look better although the car is not wire tucked, and there are wires everywhere... Here's the pics of how it came out
I've been searching the forums for help on doing a wire tuck (Without Cutting Wires), and I found that there are only a few very good walk-throughs, and most of them have pictures that are no longer available. I've never done a wire-tuck myself (until now) however, thanks to the people that put up DIY's i'm able to do it myself.
SO... I've decided to take the information I found on here and make a video to help those that want to clean up there bay but need a little more help. I want to do this with the "minimum" amount of cuttinng as I can. I'm sure some here can do this in their sleep, so everyone is more than welcome to chime in and give suggestions... I'll post more videos (or links to my YouTube videos) as I progress.
I ran the driver side harness through the windshield wiper gourmet and tucked it under the fender. Its not the cleanest job, so I think I'll go back later on and clean it up a little.
Comment