View Single Post
Old 10-09-2008, 05:23 PM   #4
arcadiacb7
CB7tuner Member
 
Join Date: Nov 2005
Location: wouldn't you like to know???
Posts: 542
arcadiacb7 is cool... so far.
Send a message via Yahoo to arcadiacb7
I used JB weld to block mine off and used a brown roloc to get it smooth on a right angle grinder. the brown won't take off the metal as long as you just maybe bump it but don't go crazy once you get close the the head. get a for sure smooth strait edge, like a machinist six inch ruler(i used it) and just go until you have no light showing once you lay the ruler over the plugged port and the IM. I also used a hondata IM gasket and skunk2 IM. good luck..
__________________
vouch for:924dr, sn2bh22cb7, soysaucecb7, ecto1, PRIMESNIPER,2.2litrebeater,turbowagon94, losiracer2,jacobuchanan140, tommi, dannyd
arcadiacb7 is offline   Reply With Quote