View Single Post
Old 04-15-2017, 09:50 AM   #23
G. Wiffington
CB7tuner Member
 
Join Date: Mar 2016
Location: Baltimore, Maryland
Posts: 291
G. Wiffington is cool... so far.
Quote:
Originally Posted by illinois_erik View Post
if you have at the minimum a torch hacksaw blade, hammer, old screwdriver or cold chisel and maybe a pointy punch you can remove the oem ones properly

getting the new RUBBER ones in just requires some sand paper, grease a stack of fender washers, bolt and nut and some wrenches.



monroe makes them for 12 bucks a pop.








**I just installed my whole suspension (shocks, springs) & I replaced these lower strut mount bushings. This method is the one I used & was probably the easiest procedure on my CB so far regarding suspension.
G. Wiffington is offline   Reply With Quote