View Single Post
Old 02-05-2009, 11:59 PM   #16
lucid
CB7tuner Member
 
Join Date: May 2006
Location: Northern VA
Posts: 638
lucid is cool... so far.
OK, This is the absolute minimum (to me at least) list of parts to order and still have a reliable swap.
I Usually buy my parts from here, they are a Honda Dealer with pretty good prices on the best parts.
Prices are current as of this post.

http://www.hondaautomotiveparts.com/...artsSearch.jsp


LOOK UP BY PART NUMBER:
>0692A-P0A-306, Front Balance Shaft Oil Seal Retainer Kit, 1.97
>08798-9031, MT Fluid, 4.69, x2= 9.38


LOOKUP BY VEHICLE:

PRELUDE 93 SIVTEC KA5MT;

>CAMSHAFT-TIMING BELT
-#11 Balance Belt, 31.70 >13405-PT0-004
-#17 Timing Belt, 52.09 >14400-P13-014

>CYLINDER BLOCK-OIL PAN
-#43 Drain Plug Crush Washer, 0.22

>CYLINDER HEAD COVER
-#1 Gasket Set, Head Cover, 35.77 >12030-P13-000

>DISTRIBUTOR
-#2 Cap Assy, 16.25, (US H22 ONLY, See 2000 Civic Si for JDM, same price)
-#3 Rotor, 14.84

>INTAKE MANIFOLD
-#2 Lower Injector Seal, x4, (not currently available from Honda?)
>16472-PH7-003
-#3 Injector Cushion Ring, 2.04, x4= 8.16 >16473-PD6-000
-#9 O-Ring for FPR, 1.51 >16741-PG7-005
-#31 O-Ring Upper Injector Seal, 2.96, x4= 11.84 >91301-PM7-003

>OIL PUMP-OIL STRAINER
-#16 Oil Filter, 4.93 >15400-PT7-005

>WATER PUMP-THERMOSTAT
-#1 Water Pump, 61.23 >19200-P13-003
-#4 Thermostat Assy, 16.79 >19301-P13-305
-#8 Gasket, therm. case (Front Waterneck), 1.02 >19313-PT0-000

>WATER VALVE-DUCT
-#4 Rear Heater Hose, 15.79


PRELUDE 92 SI;
(Manual Tensioner Conversion Parts not on F22, and new tensioners)

>CAMSHAFT-TIMING BELT
-#10 Adjuster, Balance Belt Tensioner, 49.46 >13404-PT0-004
-#18 Adjuster, Timing Belt Tensioner, 51.60 >14510-PT0-004
-#19 Timing Tensioner Spring, 3.10 >14516-PT2-000
-#20 Adjuster Plate, 7.71 >14521-P14-A00
-#25 Bolt, Timing Belt Adjuster Base, 2.93 >90014-P14-A00
-#30 Washer, 2.43 >90140-P14-A00

FOR YOUR YEAR ACCORD;

>FUEL PIPE
-#4 Fuel Filter Set, 16.89


SUBTOTAL FOR MINIMUM PARTS ORDER FROM HONDA= $462.76 before shipping.

*You will need to keep your F22 fuel rail and timing parts,
as well as reuse a clutch assembly and throwout bearing



GET THESE PARTS FROM A LOCAL PARTS STORE, ETC:

>5 Qts. 10W30 Oil, Synthetic Recommended, <30.00
>NGK ZFR-6F11 or PZFR-6F11 Spark Plugs, 12-40
>2 Gallons of Coolant, ~20.00
>Alternator belt, if needed ~20.00
>3M Windo-Weld Urethane, ~16.00
>2 Rolls of 3M Electrical Tape and some heat shrink tubing


-IF KEEPING POWER STEERING;
>New 92-96 Prelude High Pressure PS Line >53713-SS0-A51
>Honda PS Fluid
>PS Belt

__________________

The H22 Sleeper Sedan, updated 8/14
After 4 months down...It's back! and tucked.
Need a Swap or some work done in the DC/MD/VA/WV area?
PM me and get it done right!

Last edited by lucid; 02-07-2009 at 08:00 PM.
lucid is offline   Reply With Quote