If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
First of all, i've been watching this car for a while and I must say I love it! It's progressed so much, and all your hard work has paid off. Good to see you're learning as you're doing it!
Secondly, your front end reminds me alot of a Mitsubishi Legnum. I love it! Very evil.
well.. its maybe stupid, i decided to buy another CB7 more clean to transfert all my stock... you cant imagine how the rocker are rust, the floor and rain rail on the top and the engine bay, i dont tell....
but, the project are not abandoned
i keep you all on track
My Ride Thread
The fear of death follows from the fear of life. A man who lives fully is prepared to die at any time.
Mark Twain
after all that body work?? lol well i hope you are transfering everything everything, like even the doors since you shaved them! :-D
well.. i have decided to restore my car afterall...
a clean CB'z here is +/- 5000$ and i will put it on my car beside to spend it on another source of problem...
the big problem was the engine bay (because the rest are 100% restored)
so... check this out:
"The worst engine bay ever"
here my engine bay 1-2 month after i buy this accord, (4years from now)
so now, since i run my own buisness, i can spare some time to work on my car, and buid something nice, so i decided to use my experience and my talent to construct something kool.
-"Cp[Mike]" wire tuck
-PS system removed
-windshield washer system removed
-battery send to trunk
-air box vacuum removed
to come:
-EGR system be removed
-MAP sensor removed
-replace clutch line (mine choke me up last week)
-clean
-paint
Here the damage:
wire partialy hidden and intake manifolm not yet removed
Intake removed, wire hidden, have to plug the fuse box and replace clutch line
so, here my H23 Head Setup.
I will take the F22a6 runner, H23 plenum, H23 fuel rail, H23 TB, H23 IAB, make a spacer with the F22a6 IAB and have some fun..
here i go, its 3h00 am here and i go to sleep :P i send new when i sandblast,clean,paint and relace clutch line
thx for the support CB7tuner community !!
My Ride Thread
The fear of death follows from the fear of life. A man who lives fully is prepared to die at any time.
Mark Twain
you live in a really corrosive environment. you need to sand blast and powder coat as many steel parts as you can since powder coat is non-porous. later.
awesome! dude I just did the A6 intake manifold/runner swap on my A1 also! More power through the WHOLE powerband, it will feel great! Not too major but definately a bit better.
Comment