View Single Post
Old 09-13-2017, 01:18 PM   #24
G. Wiffington
CB7tuner Member
 
Join Date: Mar 2016
Location: Baltimore, Maryland
Posts: 222
G. Wiffington is cool... so far.
Innovative Mounts (not trying to drill & tap the T2W4 I just couldn't bring myself to do it lol.)

Thanks to tJoodz he figured out that with these mounts you will need to use a shorter stud on the front left bolt spot on the tranny mount (looking at the picture below) because the original trans stud is too long & will hit the body's motor mount location. This obviously does not happen when you tap into the holes for the F22 trans mount but I am not going that route. I may try to use the same bolt that the rear mount uses so that it will sit low enough for clearance. Thread regarding discussion: http://www.cb7tuner.com/vbb/showthread.php?t=209613

G. Wiffington is offline   Reply With Quote