INT: Automatic Shift Knob

[Nas92]

wait so the screws just get screwed to the shaft?is this safe?...it doesn't try sliding up any?

[popeyeamac]

no it doesnt slide up and down because they are set screws nmeaning that the tighter u put em on the more steady it is

[Nas92]

ohhhh ok, well thanks very much

[nho93accord]

Originally Posted by '93accordse

like me:



i'll write a diy soon.

that LOOKS NICE!

[nho93accord]

Ok i just got a shift boot for my auto. how do i tuck it in?

[Nas92]

remove four screws on the sides of the center console, place shifter in neutral*may need to use key to do so*then remove, if the knob is already off or its an aftermarket skinny knob then you unhook the connecter for the shift position lights unscrew the four screws holding the plate,lift up to remove,then place boot over that area replace the center back on, fix anything needed replace the screws to hold on the center console and replace your knob or if you didn't have to remove it then your already done.^_^

[MugenCb7LX]

what is the sport/overdrive button even really good for??

[popeyeamac]

nothin i just unhooked mines it doesnt do shit anyway

[1990Ex]

Originally Posted by MugenCb7LX

what is the sport/overdrive button even really good for??

shifts a lil later than normal, you could wire it to a button up to you

[Bad_dude]

I got the 2 screws on the shift knob off but I cannot remove the knob. I got that sport button which the wire goes down to the bottom which might prevent removal. Do I need to remove the sport button before the know can be removed?
Thanks.

[keepinitclean]

Originally Posted by popeyeamac

lol im going to do the swap myself i just have to find time and get all of my parts hopefully most from the junkyard lol being a mechanic is coo but sometimes sucks because its 6 days a week and i got school too lol so not much time u kno. oh heres a pic of what i did i fucking ripped the sports wires lol ill solder them on later lol

Where'd you get that shift knob? It would look sick with a boot!