So i ended up doing something stupid and drilled holes on the back side of my valve cover so that my oil lines for my catch can would be more hidden and didnt think about there being no baffling on the back side.
do you guys know of a good setup for a catch can that doesnt have baffling inside the valve cover? could i use 45° angle fitting and point them 45° "up"?
fitting would be like this
http://www.ebay.com/itm/PPD-8230808-...R29-JQ&vxp=mtr
and i drilled a hole on each end of the valve cover so i need a catch can that would support 2 lines in and have a breather
do you guys know of a good setup for a catch can that doesnt have baffling inside the valve cover? could i use 45° angle fitting and point them 45° "up"?
fitting would be like this
http://www.ebay.com/itm/PPD-8230808-...R29-JQ&vxp=mtr
and i drilled a hole on each end of the valve cover so i need a catch can that would support 2 lines in and have a breather
Comment