I’ve got some things to do to my car and plan on getting an alignment again but my caster is out of spec currently
Front left
Camber: -0.9
CASTER: 3.5
Toe: 0.03
Front right
Camber: -0.2
CASTER: 1.8
Toe: 0.01
I’ve installed
-Upper adjustable spc ball joints
-brand new upper control arm and bushings
-Lower ball joints
-Tie rod inner and outer kits
Plan to install
-Lower control arm shock poly bushings
Because the right side is lower than the other
-Poly strut rod bushing
I’m attempting to try to fix the caster because I think that’s the reason why my car pulls to the right which makes sense
I was wondering if anyone would explain and tell me exactly how many shims I can put in between the strut rod to get it back into alignment
I plan to install poly bushing when I instal the shims should I wait and instal new bushing and check the alignment for caster and then add shins if necessary?
My car has been in an accident in the front passenger side and the lower control arm was replace but I can’t remember if I replaced the strut rod could it be bent and is there any way I can measure the frame to make sure nothing is bent?
is if it’s possible to measure caster alignment at home for our cb7s?
Front left
Camber: -0.9
CASTER: 3.5
Toe: 0.03
Front right
Camber: -0.2
CASTER: 1.8
Toe: 0.01
I’ve installed
-Upper adjustable spc ball joints
-brand new upper control arm and bushings
-Lower ball joints
-Tie rod inner and outer kits
Plan to install
-Lower control arm shock poly bushings
Because the right side is lower than the other
-Poly strut rod bushing
I’m attempting to try to fix the caster because I think that’s the reason why my car pulls to the right which makes sense
I was wondering if anyone would explain and tell me exactly how many shims I can put in between the strut rod to get it back into alignment
I plan to install poly bushing when I instal the shims should I wait and instal new bushing and check the alignment for caster and then add shins if necessary?
My car has been in an accident in the front passenger side and the lower control arm was replace but I can’t remember if I replaced the strut rod could it be bent and is there any way I can measure the frame to make sure nothing is bent?
is if it’s possible to measure caster alignment at home for our cb7s?
Comment