how can i cut this lip and make it fit my cb

[reboklan]

i found this lip while i was walkin and it fts my cb bt its just a little bit wider then my car how can i cut it and make it fit on their?????

[mj213]

Try heating it up with a hairdryer of sorts. Attach it in the center (IN FRONT) and then you can reshape it.

[guitarplayer825]

You were walking and found a lip? Use a heat gun, like for peeling paint

[reboklan]

ok i can do tht bt i need to make it shorter its to wide to my car everything lines up perfect bt its just to wide

[HardInThePaint]

Get a heat gun cuz it heats up hotter than a hair dryer. Like dude said start in the center and shape it to the bumper, heating and screwing it in along the way. Then cut the ends off with a dremel or something if its too long. Don't cut it down til you shape it to the bumper so you know how much to cut.

[J3wman]

best find ever wait well the best find outside of mn. me and my friend found a Commodore 64 while dumpster diving and a turntable worth $1000

[psychogat3]

it looks just like the lip you already got on thier why waste your time? its gonna look the same.

[CB7_91/DX]

Just bolt it on the bumper and whatever sticks out on the ends just cut it.

[HardInThePaint]

best find ever wait well the best find outside of mn. me and my friend found a Commodore 64 while dumpster diving and a turntable worth $1000

Hmmm, yeah good on the turntable but the Commodore 64 not so much. Maybe if it was a Commodore 128. Maybe.

[reboklan]

ok ill do that and keeep u guys updated with pics.....bt is their a way i could measure how many inches i need to cut to make it line up perfect with my car and like mold it bck together in the middle????

[psychogat3]

ok ill do that and keeep u guys updated with pics.....bt is their a way i could measure how many inches i need to cut to make it line up perfect with my car and like mold it bck together in the middle????

tape measure? lol

[4doors]

how about a hack saw and smooth it out with some 1000 grit.

[Jccck]

best find ever wait well the best find outside of mn. me and my friend found a Commodore 64 while dumpster diving and a turntable worth $1000

That's almost justifys the activity.. Haha

As far as the lip goes, be careful or you'll have to go walking for a new one

[MWeezy]

bolt everything on and whatever is extra or too long cut it off... if it doesnt shape yu bumper then use the heat gun and bolt it so it keep the shape of how you bolted it ... it should then be good

[1clean92]

measure...and use a heat gun and im sure you will figure out something..