EXT- 4 way flash when arming alarm

[schierholz]

I debated where to put this because it was easy but was more of a how to

I didn't like my Parking lights flash every time I unlocked and locked my car

so while this may be short it's a option I thinks cool

Material's
Wire
wire stripper's
flat head screw driver for taking out the hazard switch
Alarm installed

I started by un plugging my negative battery terminal and then went to
add wire to my alarm Flash/blinker.etc with a butt end connector to
my hazzard switch and found that it controls a lot
so I took my volt meter (when the battery was still connected) and saw 2 wires that it sends voltage to to light up all 6 lights
(there it show's one wire out it goes just under that second row in) those run the blinker lights with 12 volts connected. if you try running both together it will act like you have your hazzards on when you use your blinker's so grab your Diodes and connect on to each and twist them together at the top so you don't get feed back from one another. Restore power and enjoy your amber/white.etc like a late model car as you unlock or lock with your clicker.

here is me locking and unlocking

[kosheen1]

why dont you put it on your parking lights? that way all your taillight/plate light and corners flash when lock/unlock...

[schierholz]

I decided to do this because I wanted my blinkers over my parking light which I had on my alarm for over a year becides it's another option for the CB aftermarket alarms

[evil_demon_01]

I've always done this on all alarms I fit.
I never understood why people put it on the parking lights.

They are easier to see at night too.

[schierholz]

I would say people/ installers do this because its easy to tap into the parking lights at the terminal there on the fuse box I personally really like to be able to see my conformation of the unlock/ lock since in the day my parking lights are dull since I have Oem red in back and blue's up front