CB7Tuner Forums

Go Back   CB7Tuner Forums > Parts & Performance > Technical

 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 01-20-2020, 09:37 PM   #1
dreamability
CB7tuner Member
 
Join Date: Jun 2010
Location: Dallas, TX.
Posts: 66
dreamability is cool... so far.
Intake air bypass not working.

This is an F22A6 with the stock PT6 ECU.
I am not even sure if it was even working before the full wire tuck and fuse box relocation.
I have plugged the actuator valve directly to vacuum and the system closes so no problem there.
The black/yellow wire is getting 12 volts at the control solenoid. The pink/blue wire from ECU pin 17 is getting a small amount of voltage like around 4 volts , so no problems there.
When I tie into the pink/blue wire at the solenoid and ground it the solenoid clicks and the actuator is engaged closing the IAB butterfly's. So obviously the solenoid works too. I'm at a loss here so any help would be appreciated.
Thanks.

Last edited by dreamability; 01-20-2020 at 11:46 PM.
dreamability is offline   Reply With Quote
 

Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -5. The time now is 01:21 PM.


Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.