CB7Tuner Forums

Go Back   CB7Tuner Forums > Beginner forum -- New members post here! > Beginner Technical/Performance

Closed Thread
Thread Tools Rate Thread Display Modes
Old 04-20-2010, 03:35 AM   #1
Join Date: Oct 2003
Location: New Zealand
Posts: 3,880
evil_demon_01 is someone to admire evil_demon_01 is someone to admire evil_demon_01 is someone to admire evil_demon_01 is someone to admire
Common Beginner Technical Info can be found in here. PLEASE READ HERE FIRST

Welcome to the Beginner Technical Sub forum.
This Sub forum is the place to ask any questions regarding performance, maintenance, or repairs.
If you want to go fast, or just change a flat... this is the place to ask!

First things first, We assume ALL of you have read the rules.
If you make a thread / post that goes against the rules, it will be dealt with accordingly. The rules can be seen by clicking the link below.

Threads without descriptive titles will be deleted, this applies to ALL sections.

Most General Info / FAQ's can be found below.
For more detailed info, please check the "sticky" threads in the section most appropriate for your question. MANY things are so regularly covered on this forum that the necessary info has been compiled and presented in a clear and organized fashion. Asking a question that was previously covered in a "sticky" thread will very likely get you some rude replies.

Maintenance / Mechanical / Diagnostics / Safety:
Diagnostic Checks
Car Safety Checks
Torque Specs
Tune up Specs
Timing Belt procedure
Fluid Capacities
Sensor Locations
Diagnose a Check Engine Light (also S/D4 transmission error codes)
ABS error codes
VIDEOS showing common Honda maintenance and repair procedures
Cheapest Suspension Setup to Lower Your CB7
Fuel Efficiency Compilation

H/F Series Engine Info
Erratic Idle fix
How to Set Base Idle Properly (F22ax, F22bx)
F/H Series Transaxle Info (Manual & Automatic)
How to make 30+hp for $500 or less... (DX/LX F22A1 only)
Engine Removal DIY
Frankenstein/Hybrid info

Car Safety / General Servicing Checks --------Basic suspension checks

My 5.7 LS1 Holden Ute

A "Finished" project car is never finished until its been sold.

If at first you don't succeed, Try again. Don't give up too easily, persistance pays off in the end.

Last edited by evil_demon_01; 09-06-2013 at 02:56 PM.
evil_demon_01 is offline  
Closed Thread

Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

All times are GMT -5. The time now is 02:26 AM.

Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.