Hello and thanks for taking time to read this. I'm planning on replacing the bushings on my trailing arms. I have looked and can't find anything here on how to do the job.
I know there's a lot of debate on poly or rubber. I'm just going with rubber. A stock replacement. I herd of binding and such with poly. I don't know. I just chose the rubber because I have poly on everything else plus I couldn't find them in poly. LOL
I purchased a 20 ton press from harbor freight. I just need to know if there are any special tools other than the press I would need. I plan to document it and post it here to hopefully help anyone else looking to do this. Unless its already here and I didn't look hard enough.
I will also be doing a strut job so ill document that as well.
I also wanted to ask. I replaced the lower, rear control arms and the upper control arms to adjustable camber arms. Should I also replace the lower front control arms on the rears so my toe is more adjustable on the rear than the stock arms?
I know there's a lot of debate on poly or rubber. I'm just going with rubber. A stock replacement. I herd of binding and such with poly. I don't know. I just chose the rubber because I have poly on everything else plus I couldn't find them in poly. LOL
I purchased a 20 ton press from harbor freight. I just need to know if there are any special tools other than the press I would need. I plan to document it and post it here to hopefully help anyone else looking to do this. Unless its already here and I didn't look hard enough.
I will also be doing a strut job so ill document that as well.
I also wanted to ask. I replaced the lower, rear control arms and the upper control arms to adjustable camber arms. Should I also replace the lower front control arms on the rears so my toe is more adjustable on the rear than the stock arms?
Comment