I've had some terrible karma for my CB this year. The BMC seal started leaking a few wks ago and finally got bad enough to change last weekend. I got a new one, primed it, and changed it. Easy cheese. Changed out the crusty old brake lines w/ some Techna-fit SS ones while we were bleeding the system. Equally easy cheese.
BUT! after driving a few minutes and warming up, the brakes start tightening up and the pedal gets super stiff. After a minute, it binds up and won't get out of 2nd cause it's pushing against the brakes. It's OK when it cools down. Fluid is new DOT4 and at good levels. I do have ABS (didnt work since we got the car) but dont know a thing about working on it.
This happen to anyone else or just have ideas? I wanna be running stable when the Bisi header gets in!
BUT! after driving a few minutes and warming up, the brakes start tightening up and the pedal gets super stiff. After a minute, it binds up and won't get out of 2nd cause it's pushing against the brakes. It's OK when it cools down. Fluid is new DOT4 and at good levels. I do have ABS (didnt work since we got the car) but dont know a thing about working on it.
This happen to anyone else or just have ideas? I wanna be running stable when the Bisi header gets in!
Comment