Hey guys,
Well I have a question. First off. I have a '95 accord wagon I'm building. Its a F22b2. Fully built motor. With a PTE 5862 on it. Full built transfer with mfactory LSD. I did a full wire tuck and shaved bay. Now for the question.
When I did my wiretuck. I did it on a engine stand when the motor was out of it. I labeled most of the connectors. Some I forgot to do like an idiot. I figured them all out from.my Haynes manual. Except for one. It is a 3 pin female connector. With two I shaped cut outsbetween the wires. If the locking clip is on the Roland your looking at the connector side the wire colors are yellow/blue stripe on the left. White/black stripe center and green/blue stripe on the right. Does anybody have an idea where it goes too or where I can figure it out? Thanks in advanced!
I dont know how to post pictures. But, The connector looks like this if your looking at it.
-I-I-
Well I have a question. First off. I have a '95 accord wagon I'm building. Its a F22b2. Fully built motor. With a PTE 5862 on it. Full built transfer with mfactory LSD. I did a full wire tuck and shaved bay. Now for the question.
When I did my wiretuck. I did it on a engine stand when the motor was out of it. I labeled most of the connectors. Some I forgot to do like an idiot. I figured them all out from.my Haynes manual. Except for one. It is a 3 pin female connector. With two I shaped cut outsbetween the wires. If the locking clip is on the Roland your looking at the connector side the wire colors are yellow/blue stripe on the left. White/black stripe center and green/blue stripe on the right. Does anybody have an idea where it goes too or where I can figure it out? Thanks in advanced!
I dont know how to post pictures. But, The connector looks like this if your looking at it.
-I-I-
Comment