CB9 H22 teardown/build/wire tuck

[cb9tuner]

well i rerouted the bay harnesses I cut a hole in the passanger side and routed it thru and exsisting hole , and used a wire brush to take off that gunk stuff wow if any of you seen what my car looked like after my accident I need to reweld my driver side panels and motor mount , as of my motor wise I really havent done much but take apart my head down to the valve train and my block has some scores I can feel them with my finger nail sucks might need to get it machined but kind of at a stop right now since I got a truck and going to puerto vallarta for 12 days , but Ill post some pics tommarow of the progress

dont work on your car if its 105 outside and your working in the bare sun you tend to get burnt I look like a dang 6 foot tomato

[90exaccord]

well i rerouted the bay harnesses I cut a hole in the passanger side and routed it thru and exsisting hole , and used a wire brush to take off that gunk stuff wow if any of you seen what my car looked like after my accident I need to reweld my driver side panels and motor mount , as of my motor wise I really havent done much but take apart my head down to the valve train and my block has some scores I can feel them with my finger nail sucks might need to get it machined but kind of at a stop right now since I got a truck and going to puerto vallarta for 12 days , but Ill post some pics tommarow of the progress

dont work on your car if its 105 outside and your working in the bare sun you tend to get burnt I look like a dang 6 foot tomato

dam you going to MEXICO?? have a good one over there ive always wanted to go there tell the mariachis i said wassup!

[ap716]

nice, cant wait for final pics

[cb9tuner]

long awaited pics of my starting atempt to wire tuck



feakin battery acid

[cb9tuner]

[cb9tuner]

well I removed the rods and this I what I found
rod #1




rod#2




rod #3




rod #4




all the inner races look fine normal wear on the outer edges what doe you guys think?? I hope I dont need new rods

[cb9tuner]

[bmxicansd]

whoa just saw this thread.. Good luck with the build Jason.. Wire tuck ftw

[cb9tuner]

whoa just saw this thread.. Good luck with the build Jason.. Wire tuck ftw

ha ha thanks craig looks like shit right now but in time it will look pretty dope

[cb9tuner]

bump for some help on my rods all the marking are not deep I cant feel any of the but rod #3 has a dot cat feel it but looks suspect

[NAiL05]

Pitting and some scoring you might be able to get those machined but might as well put in new stuff.

[bruno8747]

Rods are fine, Thats the coating from the bearings that gets on the journals. Nothing major.

[cb9tuner]

Rods are fine, Thats the coating from the bearings that gets on the journals. Nothing major.

really sweet than thanxs bruno, so im going to measure them just to be safe for out-of-round and throw new bearings and measure and inspect the crank just need to get final measures done and order all parts at the same time

[Night Wolf]

are those the stock ones?

[cb9tuner]

are those the stock ones?

yea the stock h22a rods