CB7Tuner Forums

Go Back   CB7Tuner Forums > Beginner forum -- New members post here! > Beginner Audio/Electronics

Reply
 
Thread Tools Rate Thread Display Modes
Old 09-18-2019, 12:45 PM   #1
K2theM
Newcomer
 
Join Date: Nov 2013
Location: Vancouver, WA
Posts: 18
K2theM is cool... so far.
Installing Keyless - Missing some wires

I have a 1990 EX that I just installed an aftermarket Keyless entry system in. Through other threads on this forum I found various guides and wiring conversions that were really helpful. I was able to successfully install the module and have fully functioning remote Lock/Unlock + Parking Light Flash (Kinda wish it was Hazard flash instead of Parking... but it works).

However, I'm missing on a couple things that I would like to have:
  1. Where is the Horn wire? It's supposed to be a Light Green/Blue wire in the steering column harness. However I was not able to find it. Maybe I was looking in the wrong spot?
  2. I have power windows, and the module has an Auto Window Up function. How do I properly hook this up? I've read some places that say I'll need a separate module to control this, and others that say to just run four wires from the window control board to the module. Which is correct?

The module also has trunk pop functionality, but I know I'll need to rig up a separate solenoid or swap out the catch unit to make this work. I'll tackle that another time.
K2theM is offline   Reply With Quote
Old 09-18-2019, 08:10 PM   #2
sonikaccord
Contributing Member
 
Join Date: Nov 2005
Location: In Traffic
Posts: 4,244
sonikaccord seems to have made some friends!
Horn wire is under the dash under the steering column trim I believe. Since you have a '90, you don't have an airbag, and there should be one or two small gauge wires running under the trim. Those are your wires.

Power windows, you can run 4 wires to the switch panel harness on the door. Make sure to diode isolate the 4 wires.
__________________

YouTube Clicky!!
sonikaccord is offline   Reply With Quote
Old 09-19-2019, 11:39 AM   #3
K2theM
Newcomer
 
Join Date: Nov 2013
Location: Vancouver, WA
Posts: 18
K2theM is cool... so far.
Yeah. After doing some searching and some testing; I'll need to do the following:

1. The horn is the Blue/Red wire at the steering column plug, but it switches ground. The Module I have switches live and is normally grounded. So when I hook the module up directly to it the horn blasts constantly. I can get this to work by using a relay that is activated by the module and provides a ground to the horn circuit.

2. Looking through the wiring diagram for the Power Windows, your suggestion is correct. Using diodes would be much better and more compact than the 4 Relay idea I had.

Thanks!
K2theM is offline   Reply With Quote
Reply

Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -5. The time now is 05:39 PM.


Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.