So… for three months, or more, I’ve been trying to figure out why when my car is cold it starts right up and will run all day but as soon as I shut it off it will not start back up till I wait for it to cool off.
now it just got to the point where it doesn’t start at all. I have done quite a bit of work to her.
NEW REMAN HEAD
HEAD GASKET
TIMING BELT N WATER PUMP
ALTERNATOR 200 amp
FUEL PUMP
PRESSURE REGULATO
FUEL RAIL
FUEL FILTER
LIKE THREE DIFFERENT DIZZYS
Not to mention suspension and other things that just needed to get done. I’ve had her 16 years now and I will keep her running. 297000 miles.
I went to the junk yard and got a complete harness for a manual and have been going almost every day to take parts off her being these are hard to find now and this one is a complete LX manual.
the only thing different on the harness is the auto trans connectors so I had to remove the connector from the old harness and repinn it to the new one.
my question is, are the color codes the same for the wires from a manual to auto? So if the green wire with blue stripe the same on both? I hope so cause this took me a long ass time and it needs to work. Sorry about the ADHD on this question but I’ve been looking and I’ve seen no one try this with a stock harness.
now it just got to the point where it doesn’t start at all. I have done quite a bit of work to her.
NEW REMAN HEAD
HEAD GASKET
TIMING BELT N WATER PUMP
ALTERNATOR 200 amp
FUEL PUMP
PRESSURE REGULATO
FUEL RAIL
FUEL FILTER
LIKE THREE DIFFERENT DIZZYS
Not to mention suspension and other things that just needed to get done. I’ve had her 16 years now and I will keep her running. 297000 miles.
I went to the junk yard and got a complete harness for a manual and have been going almost every day to take parts off her being these are hard to find now and this one is a complete LX manual.
the only thing different on the harness is the auto trans connectors so I had to remove the connector from the old harness and repinn it to the new one.
my question is, are the color codes the same for the wires from a manual to auto? So if the green wire with blue stripe the same on both? I hope so cause this took me a long ass time and it needs to work. Sorry about the ADHD on this question but I’ve been looking and I’ve seen no one try this with a stock harness.
Comment