Best way to change headlight - low beams

[Accord07]

Re

No go. It's just too dang tight. I can make it budge what's so ever.

Anyone have any luck ? Or any method ? I may take a zip tie and tug on the bottom

[Accord07]

Re

Yeah I'll give it a shot tomorrow. It's poorly designed in that sense

[cp[mike]]

I've had great luck with the hammer and screwdriver trick.

Some lubricating spray would also help - LiquidWrench and PBblaster both should be safe on plastic/rubber.

[Raf99]

I would do the hammer and screw driver trick. Tap it one way a few times, then the other way, then back the other way. Little light taps, see if you can loosen it up. Besides that, wear gloves + two hands, and lots of strength.

[Accord07]

Hello !

It's been more than 10 years since I changed bulbs on a CB7

I can't unlock the ring on the low beams. Without that I can't get the bulb out. Anyone faced a similar issue ? What was the best option or method on opening it ? Thinking about tapping it with a hammer and a flathead but not trying to break it.

Any help would be appreciated !