Announcement

Collapse

Please DO NOT Post In The General Section

From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.


The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.


For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.


Everyone will get a couple of warnings from here on out, after that I just start deleting threads.

Again if you have any questions, PM me or one of the other mods.
See more
See less

Engine torque-rod setup....

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
    #1

    Engine torque-rod setup....

    Ok, so as part of my winter project something I would really like to do is install a custom torque-rod engine damper. something that would go from the engine to the firewall, or to the radiator support, something to eliminate engine torque twist, and put more power to the ground.

    i was wondering if anyone has tried anything similiar, or if anyone has any tips for trying it.
    The CB7 Timeline
    Tags: None
Previous template Next
Working...
X