turbo startup expectations..

Please DO NOT Post In The General Section

From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.

The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.

For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.

Everyone will get a couple of warnings from here on out, after that I just start deleting threads.

Again if you have any questions, PM me or one of the other mods.

See less

westsideaccord replied

06-03-2005, 06:59 AM
Whoa! whole lotta transfers, lol, yeah hes workin on a basemap for me I think?
Leave a comment:
90_accord_dx replied

06-03-2005, 04:32 AM
haha its cool man, mrx allready made a basemap with uberdata for me.. i jus gotta get it from him.. sending the money out later today to lxrida.. and he shall send the money lxrida owes mrx, then I from what I have been told.. mrx is then gonna send it to me when he recieves lxridas money
Leave a comment:
westsideaccord replied

06-02-2005, 08:20 PM
well I am just saying it could happen! Relax guy, I am just trying to get a rise out of yah! Peace! P.s. Im sorry if it annoyed you, but I am sure if you hooked up everything right and fed the turbo some oil and made sure there were no leaks, oil or air, than the last thing is wether or not the basemap is good for your setup, if it runs to lean or to rich! Just my 2 cents

Last edited by westsideaccord; 06-02-2005, 08:26 PM.
Leave a comment:
90_accord_dx replied

06-02-2005, 08:14 PM
uh.. that didnt help at all.. please keep youre useless posts to youreself, thank you
Leave a comment:
westsideaccord replied

06-02-2005, 03:28 PM
BOOM
Leave a comment:
90_accord_dx replied

06-02-2005, 02:05 PM
yeah, Ive heard that before u accually start it, to have it turn over a few times, to pump some oil thru
Leave a comment:
92ex replied

06-01-2005, 11:21 PM
tightened down all manifold bolts, but still clicking. my guess is exhaust manifold, since I still have the used one on. I have a new one, I was waiting on putting it on.
Leave a comment:
h22sparkle replied

06-01-2005, 07:06 PM
lol and make sure you oil lines are primed dont want to starve out the turbo from its food.
Leave a comment:
Accord R33 replied

05-26-2005, 06:15 PM
Originally posted by 92ex

mine kinda makes a clicking when going. everything runs fine though. a little bit of oil comes out of the compressor though. should be fine

clicking?? make sure your manifold to turbo bolts are tight. mine was clicking for a few weeks and i couldnt figure out what it was for the life of me. turned out to be the manifold bolts being loose
Leave a comment:
92ex replied

05-26-2005, 05:58 PM
mine kinda makes a clicking when going. everything runs fine though. a little bit of oil comes out of the compressor though. should be fine
Leave a comment:
Hanzino replied

05-26-2005, 05:29 PM
motor wont start, boost leaks, clutch slipping, hmm cant remeber anything else off the top of my head.....
Leave a comment:
90_accord_dx replied

05-26-2005, 05:03 PM
well yeah, I know that, I was just wondering if there is anything that kinda goes wrong with everones set up.. like any commen things that go wrong
Leave a comment:
micksf22accord replied

05-26-2005, 04:39 PM
get on aim/msn im
Leave a comment:
90_accord_dx started a topic turbo startup expectations..

05-26-2005, 04:26 PM
turbo startup expectations..

assuming I install everything correctly.. on initial start up, what are the possible things that could go wrong? id like to be ready for whatever I CAN be ready for, lol
Tags: None