Announcement

Collapse

Please DO NOT Post In The General Section

From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.


The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.


For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.


Everyone will get a couple of warnings from here on out, after that I just start deleting threads.

Again if you have any questions, PM me or one of the other mods.
See more
See less

spool up times (different turbos)

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #31
    i have no idea the a/r's bc ihi sucks bc they dont publish the shit~ i have looked everywhere!

    My dp is pretty free flowing, it was custom made by my brother, has awesome curves and welds, and an open dump, no cat, and 2.5 inch from dp out the back, and is mandrel bent, not crush bent. So i am pretty much getting spool as early as i can lol.

    d112~ check my members ride page
    My baby laying down some power...

    http://www.youtube.com/watch?v=kd_Q8HSIyqA

    Comment

    Working...
    X