Ive been trying to look for pictures that show well what route the right side intercooler piping can take to get to the turbo. It seems the area here is pretty compact, just wondering if people were drilling through or going under ?
Announcement
Collapse
Please DO NOT Post In The General Section
From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.
The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.
For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.
Everyone will get a couple of warnings from here on out, after that I just start deleting threads.
Again if you have any questions, PM me or one of the other mods.
The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.
For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.
Everyone will get a couple of warnings from here on out, after that I just start deleting threads.
Again if you have any questions, PM me or one of the other mods.
See more
See less
Good pics of right side intercooler piping
Collapse
X
-
use your head..you dont need a masters engineering degree to figure it out..
and look at this. http://www.cb7tuner.com/vbb/showthread.php?t=31591
Owner of https://theclunkerjunker.com
Comment
-
It's a Prelude but pretty much the same
used a 2.5" - 2.75" coupler to go from the IC pipe to my AEM cold air pipe that was already there
If you're talking about the driver's side, I hope Accords have a little more room than mine did, had to cut a hole through the "frame" to fit the piping the way we routed it
Last edited by mullet; 05-24-2006, 09:50 AM.1993 Prelude S
F22A1
custom'ish turbo setup
180 whp/217 ft-lbs super hot, super humid, super rich, boost falling off at 8psi
18psi boost spike = BOOM!!!!!
currently being rebuilt
Comment
-
Originally posted by starchlandcool those pics help, the driver side looks to be the real challenge.
Owner of https://theclunkerjunker.com
Comment
Comment