Lol... Is there actually a "set" equation to figure it out? Just wondering... Thank you for all the info HondaFan! Helps me a lot!
Announcement
Collapse
Please DO NOT Post In The General Section
From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.
The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.
For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.
Everyone will get a couple of warnings from here on out, after that I just start deleting threads.
Again if you have any questions, PM me or one of the other mods.
The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.
For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.
Everyone will get a couple of warnings from here on out, after that I just start deleting threads.
Again if you have any questions, PM me or one of the other mods.
See more
See less
milling an H22 head
Collapse
X
-
Originally posted by HondaFan81.010" mill about 11.0
.015" mill about 11.1
.020" mill about 11.3
.025" mill about 11.4
.030" mill about 11.6Last edited by HondaFan81; 01-04-2006, 10:32 AM.92 DA9 // 93 D21 4x4 // 92 CB7
Comment
-
Originally posted by 92exhondafan, im not sure if its sickening how much you know, or im just jealous...
Comment
Comment