mix & match motor

[RaccorR]

ok im trying to build up a new motor since my f22b jdm just blown up on the hight way

just got my hand on a f22b2

this i what im trying to do

-F22b JDm head
-f22b2 bloc
-H22 crank & Rod
-f20b piston ( i thinks these are the only one that would fit , any idea??)
-do i need better injector?
-is there any aftermarket cam for f22b jdm head?

im starting a new project i would definatly need some advice before starting spending all my money

thanks

[cb7wagonPL]

how did your jdm F22B just blow up...on the highway???
seems like you are just trying to throw a bunch of parts together and hope it works. did you think how all this will be controlled via what ecu?

[RaccorR]

yup , there was an oil leak somewhere that i didnt saw...160 on the high way and BAM!

surprisingly the head is still ok


for the ecu i still didnt figure this out yet


but is this possible , or very risky?

[cb7vtec]

i know there are some delta cams that go to the f22b. you can get em online

[d112crzy]

anything that is for an h23 head you can use for the f22b head.

[RaccorR]

i already know this , but thanks for the info

but is my project ok? or completly insane and dangerous ?

[MadSpleen85]

i already know this , but thanks for the info

but is my project ok? or completly insane and dangerous ?

Depends on your experience as an engine builder? Ever done it before, built or tore down and rebuilt a motor? For all I know you could be a master engine builder, or you could be like me... Never seen the internal workings of your stock motor. Sounds like your going for the ULTIMATE FRANKENSTIEN Motor. Later

[RaccorR]

is there any way i can use a f23 block (odb2) on a f22b jdm head(odb1) ???

so that i could fit some lude type s piston in there

[92ex]

yes you can....do some searching please...actually, a lot, and some research

[RaccorR]

yup , thanks , i didnt know this was discuss before


i got another question , is there any gain if i use a h22 crank and rod from the h22 and keep the same piston(f22b2)?

this is the part missing , what does that a crank is better than another...

[92ex]

http://cb7tuner.com/vbb/showthread.php?t=41915

have fun. dont ask anymore questions

[RaccorR]

i already have this , i just wanted to know some opinion

[JDMCB3Si]

why not pick up an f22a block and drop your f22B head on it and use a higher compression piston instead of trying to frankenstein a bunch of parts together in hopes it would work. If your dead set on the type s pistons and h22 crank and rods then have the f22 block bored and stick them in.

[RaccorR]

well .... could it be possible just to bore the cylinders to 87mm and stick the h22 piston with the f22b2 rod and crank ?

[RaccorR]