If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Announcement
Collapse
No announcement yet.
EXT: A Complete USDM Black Housing DIY W/ PICS!!! (56K Be Warned!!!)
I've got some regular rustoleum flat black spray paint...think it'll be the same? or should I go with that BBQ stuff. Just trying to save a buck since I already have the rustoleum flat black
once i grow a set and am not scared to ruin my only set of headlights I'll definitely give this a try! Maybe ordering some amber corners will give me some incentive...
Any way, nice DIY dude! Bookmarked on my computer!
once i grow a set and am not scared to ruin my only set of headlights I'll definitely give this a try! Maybe ordering some amber corners will give me some incentive...
Any way, nice DIY dude! Bookmarked on my computer!
If you take your time, you should have nothing to worry about, just gotta be careful w/ the glass right when you take it out of the oven, pry w/ the screwdriver very carefully and slowly.
member's ride thread
93' EX Coupe H22A w/ P2T4 Sir 5spd 191whp 155 wtq
99' Lexus LS400 157k VVTi V8 gets up & goes...new DD
91 Accord SE 176k
97' Honda Odyssey 199k miles...$485 spare van for my parents
well here's mineeeeeeee
funny cuz this is like my 15th blackhousing jijijijijij
enjoy
PS for all the people that think is too expensive
i did this one with
99 cent black flat paint
5$ yellow glass paitn
1$ roll of tape
1$ 100 razor blades
0$ creativeness
350 degrees
for 3 min
40$ snap-on flat head screwdriver
same glue used, (people its glueeeee doesnt matter if its 10, 20 40 years old its still glue)
well here's mineeeeeeee
funny cuz this is like my 15th blackhousing jijijijijij
enjoy
PS for all the people that think is too expensive
i did this one with
99 cent black flat paint
5$ yellow glass paitn
1$ roll of tape
1$ 100 razor blades
0$ creativeness
350 degrees
for 3 min
40$ snap-on flat head screwdriver
same glue used, (people its glueeeee doesnt matter if its 10, 20 40 years old its still glue)
I've asked this question on a separate thread but never got an answer. Can you blackhouse oem corner lights? I bought amber corners and they're not to bright coz they don't have the reflectors on the sides, so I was thinking if I can blackhouse my oems and just paint the inside of the glass orange?
Comment