SWAP: Cruise control usage with 5spd swap.

[Quashish]

@mishakol

All I remember was I had to wire it backwards to get it to work.

[Mishakol129]

@mishakol

So wire the black to pink and pink to black? But why is it that the OP says that he wired it normally and it worked fine (that is, with the auto CC module)?

Cause wiring it up backwards as owequitit says is for when you don't have the auto CC module.


What do you make of this?

" I am currently using the auto cruise unit and have tested the cruise up on jack stands, lol, and it seems to work fine!"

I have tried it with the MT module and it did not work. Should I really hook it up backwards? But that not what the OP said to do.



EDIT:


I'm going to re install the MT CC module and see if that fixes it cause before I had a different brake switch hooked up and the grommet was missing, there was just a metal screw in its place and that could have messed with the continuity causing CC not to activate cause the brake switch is connected to the CC switch.

Then again according to the OP CC should work regardless if its a MT or AT module...

[19dabeast85]

If you're testing this on jack stands be aware that the cruise will not activate below a certain speed/rpms. I thinking the cutoff is 35mph, no clue on rpms but 4th gear at 35mph it will activate.