If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
They penetrated just fine. You can tell by the hue on the edges of it. They look great. Just at the end when you end your bead, swipe back so you dont leave that flat spot in the end.
to you!
"you can catch me swoopin 4G coupin switchin lanes" haha haha.
1993 SE coupe drag car ahoy!
1992 EX coupe 5 spd **sold **
1991 LX sedan 5 spd **tore the tranny apart**
sold to: jakfrostwhite,F22Cb7Rid3r, and many others
Did work for: jhoff_cb7
Traded with: 1990AccordEX,pr3pg4lyfe
They penetrated just fine. You can tell by the hue on the edges of it. They look great. Just at the end when you end your bead, swipe back so you dont leave that flat spot in the end.
nice and smooth. But I was gonna question your penetration as well...but i dont know i dont weld
"You've done more threatening prescription drugs..."
"the character of a man can be judged by how he takes his criticism"
"Quoting yourself is like, masturbation" -Starchland
get some more scrap and put like 100% bevel on both sides \/. Like that. Then run some stringers
first weld- Right in the middle
second weld- Just on one side of the first enough to leave room for a third on the other plate.
third weld- descibed above
fourth weld- cap off those welds with a weave that covers the others that just barely over laps on top of the plates.
This will be one of the strongest welds you can make. some people disagree with weaving but the stringers underneath it will still be hot and will let that metal melt easier and in conjuction create better pen. PEACE
Comment