If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Just get a chipping hammer and chip the slag off. Its not that hard.
actually i was just going to slow and i bumped the air pressure 3 psi. i also began making the mounts for the bar to the strut mount. it looks kinda poopy though
I <3 G60.
0.5mm Oversized Stainless valves and bronze guides available. Pm me please.
Comment