tonystyle27 : 1990 Accord LX

[tonystyle27]

Due to the fact it snowed again here in Louisiana( the world is coming to a end in 2012 collect your can goods) i didnt get much done. All i did was seperated the trans from the engine and cleaned up the engine bay a little. Hopefully i can get out to the wrecking yard to pick up my spare wiring harness for my soon to be wire tuck.

[tonystyle27]

Well this week i got the car back on all fours. now i have came up with a list of things i want done/installed before the motor goes back end. then the fun will continue

[tonystyle27]

Top Ten List
this is my list of what needs to be done/installed before f20b goes back in.
1.T2S4 Transmission
2.Skunk 2 intake manifold
3.Skunk 2 68mm throttle body
4.wire tuck
5.engine bay painted
6.water pump replaced
7.timing belt replaced
8.lightend flywheel
9.stage 2 clutch
10.aem fuel rail

[tonystyle27]

well i printed out the diy wire tuck for our cars so i will get busy on doing that soon. also remove the ac components and cleaned/primer the engine bay. now trying to fiqure out what color should i paint the engine bay. the car is going back to the color i chose before the red. so what would make my engine bay stand out. please send me suggestions. thanks

[mercyboy]

Good job on the car....keep up the good work bro

[AnewOasis]

Hey man I am doing an H23a Vtec swap in my car. I know the F20b and the H23a have the same engine bracket. How did you use the F22B1 engine mount on your car. I shaved mine down like you said but it lifted the engine a little too high and was hitting the hood. I had the put some spacers to make it somewhat level and close the hood. Is this what you have to do?