Megarock15 : 1991 Accord DX

[megarock15]

hey everybody i have finally haad time to make my mrt for my coupe!

if any one remembers hondafan's 91 phoenix red dx coupe this is it reverted back to stock















so this is what i am starting out with

current base
f22a4
a4 complete exhaust
yeamens short shifter
12 lbs flywheel
sri
rear upper chassis support
ex alloys

mods i have done
95 ex rear crossmember swap
95 ex rear disc swap
95 ex rear sway bar
9293 front bumper
9293 headlights

mods in process
new Eagle 9293 headlights with amber corners
lexus fogs
9293 10th anniversary trunk swap
9293 red clear tails
pt6
A6 cam
h23 custom intake manifold and tb
custom ebay stainless steel header and 2 1/2 " exhaust
22" magnaflow resonator
18" ebay resonator
2 1/2 " obx dual tip oval muffler
15" Enkei T Forks with new rubber

future mods
bisi level 3 turbo cam
bisi valve train
1 mm oversized intake and exhaust valves
lighter flywheel
either precision or garrett turbo maybe hoslett
blue print and balance engine
sleeved block
probably aris pistons with eagle rods
head work to optimize bisi cam

[megarock15]

reserved

[megarock15]

reserved for body work

[megarock15]

reserved for fabrication

[keepinitclean]

OOBER rare color! Glad to see you are saving her from that nasty cancer though! I'm sure she'll look great!

[Accrdwgnguy]

Youre going to save this car? Best of luck to you sir

['93CB7Ex]

that rust is terrible.

[megarock15]

i know this poor thing has stage three skin cancer like a mother trucker but thats what happens in michigan.

i have started fabricating some of my exhaust last night i have that posted in the diy/welding section. just wish it was warmer out.

now that i have a jobby job i hope things will be going alot faster now

[megarock15]

Quick update! I started it up for the first time today in over a year! I let her run for about twenty minutes and it started to over heat. When I looked under the hood I noticed that the fans where not working and there was a lot of steam shooting out from wheree the head light bracket is by the over flow tank is for the coolant. So now I need to test the fans and see whats up with that. If any one has any advice let me know.

[megarock15]

another update

so i was out trying to finish my disc swap today and i needed to replace the softlines on each side from the chassis to the trailing arm. guess what happens the flare nuts are fused to the hard lines and the hard lines just rip like wet toilet paper.

so i am going to the dealership tomorrow to order new hardlines.

next step is to disassemble the rear knuckles to remove and replace the hardlines