SSMAccord
CB7tuner Member
Last Activity: Yesterday, 11:19 PM
Joined: 08-29-2004
Location: Little Rock, Detroit Metro
-
Yeah, that looks really well maintained. -
The brass bushing should be in the flywheel already.Leave a comment:
-
If there is a Phearable basemap already loaded into the ECU, you should be fine for testing and making sure all of the parts and wiring are working as they should be. (Also like Raf said, I am not a professional...Leave a comment:
-
You will need manual CB Accord left and right axles, as well as a CB or CD Accord intermediate shaft.
The automatic Accords don't have an intermediate shaft instead they use unequal length...Leave a comment:
-
Those fittings are very difficult to thread in. I think it is due to the stiffness of the hard lines. The way that I usually tackle the task is by loosening the rack mount bolts so that it can move/rotate...Last edited by SSMAccord; 06-04-2021, 04:34 PM.Leave a comment:
-
I think the MR2 pump is typically mentioned because it was one of the only EHPS pumps around when people started doing that mod way back when. Today they are kinda impractical as they are quite rare and...Leave a comment:
-
Not at all, the failure state is that the pump would not work or not produce pressure. If there was a pressure situation, the pump doesn't put out enough pressure to take control of the wheel and would...Leave a comment:
-
That is my setup lol. It has proven to be reliable, considering I only drive it 2000 miles a year or so. The wiring is fairly straightforward, there is a way to wiring in the error light as well. ...Leave a comment:
-
That does sound like a belt being very tight. What tensioner set up are you running?Leave a comment:
-
The wires for the door unlock and lock are behind the driver’s kick panel. Unlock is Black w/ Red stripe, Lock is Black w/ a White stripe. I think this a 2 pin connector that is taped to one of...Leave a comment:
-
Looks so good finally resting in the wagon engine bay! You definitely had a bit of a battle getting it in place. I hate how indifferent the fitment can be on the aftermarket parts are for these cars....Leave a comment:
-
Good progress. Getting down to wrenching at 6am is a feat! But it seems to have been time well spent.
The PS mounting is a tricky situation, I think you've chosen the most available solution...Leave a comment:
-
This looks like a blast! Are you having wheel spin on the inner tire?...Leave a comment:
-
Most of the parts meant to address the weak points that showed up during the track day have arrived.
Upper Control Arms. These came from Rockauto, the image indicated that these would have...Leave a comment:
-
Thanks. You definitely should, it really is a great way to enjoy the car that you've built!
I think the armrest is worthwhile addition. It is lower than the seat mounted armrest and sits...Leave a comment:
-
Thanks! It was an entertaining trip. I cant wait for the next outing, perhaps at the end of the month but most likely in July....Leave a comment:
-
You definitely did a lot of work to get to look so seamless.Leave a comment:
-
Sucks about the crank pulley. Also, I hate when the wiring on those 2 pin connectors break off like that. I have never been able to depin one successfully.
But this looks like a step toward...Leave a comment:
-
This looks like a fun ride.Leave a comment:
-
Good race!!! There were a couple of dicey moments where you managed to stay in control.Leave a comment:
No activity results to display
Leave a comment: