A quick search yielded some results for you:
https://www.cb7tuner.com/vbb5/forum/...ecurity-system
The electrical PDF guide will point...
daovangphotos
CB7tuner Member
"Day by day..."
Last Activity: Today, 12:33 PM
Joined: 12-18-2009
Location: Central USA
-
Happen to know instructions to install an oem alarm? -
Personally, with the age, I'd go through and re-do all the fluids and gaskets too, if it wasn't already done. (With OEM Honda parts)
Everything has a shelf/service life not just based on miles,...Leave a comment:
-
I only run the iridium from NGK for my H22, as mine is n/a.
Here, you may use this site to reference part numbers.
Unsure how hot or cold you need your plugs to be, but the plugs found...Leave a comment:
-
All LED Retrofit ALL CLEAR tail lights
-
Damn!
For a wagon, that thing keeps up close to the rest of those cars!Leave a comment:
-
I've always used Honda gaskets for my motor.
When I was still on the F22A6, I went through ALL of the parts store valve cover gasket, and always had a leak.
Went to the Junk...Leave a comment:
-
FrostyCB9
Typically with any swaps, it is always best to check the grounds.
They play a huge role in the ECU and sending spark/fuel.
Main grounds, since you did an engine...Leave a comment:
-
FrostyCB9
Because the vehicle is already OBD2....
I would've used original harness from the BB6.
Swap dizzy for good measure.
Crank sensor/oil pump.
Would've left...Leave a comment:
-
FrostyCB9
Nice wagon!
With little to no mechanical and DIY knowledge, you are moving pretty fast in your resto-mod!
I applaud you!
When i had my double stacked...Leave a comment:
No activity results to display
Leave a comment: