Fleetw00d
Contributing Member
Last Activity: Yesterday, 11:19 PM
Joined: 03-04-2007
Location: Southwest Ohio
-
Still want the trunk panels and carpet? -
The first picture above is looking up into the right rear wheel well/spring-shock tower. The second picture is looking down on that same body section from above with the rear shelf portion removed (base... -
I had a low air dam on my 82 Chevy Citation X-11 - a rabbit punched a hole through it at 80 mph. I was on a two lane back road so I wasn't going to try to dodge him....Leave a comment:
-
How tough is it to learn to use an arc welder? Some of the the areas on the original body appear to have been welded with an arc welder, not spot welds? Local Rent-a-tool place has one available. Might...Leave a comment:
-
Studied the chunk of quarter panel to attempt to figure out a way to replace the quarter without splitting the wheel well opening spot welds. The weld joint between the inner wheel housing and the floor...Leave a comment:
-
Opportunity for a DIY. I'll take some pictures as I go when the hardware gets here.
Edit: Parts were all available today. Installed everything and adjusted. Unfortunately, one of the wheel...Last edited by Fleetw00d; 04-19-2021, 10:59 PM.Leave a comment:
-
It was primarily my hip; they looked at my back because they thought there might be a pinched nerve or something there that was showing up as hip pain - it's all good. I won't go into the circumstances,...Leave a comment:
-
I had problem with mine dying between shifts if I took too long. May be a long shot - check your coolant level and bleed it to make sure the FITV has coolant getting to it.Leave a comment:
-
Finally did something about my soft brakes. I had rebuilt the master cylinder a while ago; that seemed to help some at the time. Took a look at the rear brakes; still a fair amount of material on the...Leave a comment:
-
I know how life can be; I'd make an attempt to get it running (makes it easier to move around) and you may need to drive it in the meantime. I just can't imagine how shifting from neutral to first would...Leave a comment:
-
You can get new bleeder screws if you can get the old one out; otherwise a new wheel cylinder with a new screw will fix it.Leave a comment:
-
Back in the day, I just cut a big hole in the bottom of the air filter box. Got a nice roar out of it, but my wife was driving it some back in those days and didn't like the noise.Leave a comment:
-
When you say "stabilizes", stabilizes at high idle (seconds after starting), or are you letting it get to operating temperature and the idle stabilizing at around 750 rpm? You depressed the...Last edited by Fleetw00d; 04-10-2021, 08:43 AM.Leave a comment:
-
I hope the rest of this one was a total wreck. Also it is 92-93, not 91 (sent him a note). Might be worth it if someone needs the bumper, headlights, and corner lights (assuming they aren't boogered...Last edited by Fleetw00d; 04-10-2021, 12:46 PM.Leave a comment:
-
Give me a ZIP and I'll calculate shipping for the roof strips and quarter moldings. -
There were some neighborhoods around here that put them in, then wound up with people speeding between them to make up the time it took to go over them. They eventually removed them.Leave a comment:
-
Welcome! Looks pretty good from that angle.Leave a comment:
-
Grrr. I hate paying other folks to service my vehicles. She experienced a crank, no-start issue a few weeks ago. Let is sit 15 minutes and it would start fine. Sent her a volt meter to check battery...Leave a comment:
-
Correct. Pods are the same in either coupe or sedan.Leave a comment:
-
EX/SE pods fit 6x9 speakers. LX pods fit 6.5 inch round speakers. The pods themselves can be switched; the exterior size and mounting is identical. Best bet is a U Pull yard. The fabric on the top part...Leave a comment:
No activity results to display
Leave a comment: