Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
CyborgGT, cannot move the bracket as the caliper is mm away from the rotor inside of it. I really need a wider wheel or one that doesn't have the "lip" where the wheel weight goes. OR I shave...
-
Yaaa.. i did not know this :\
For those left on this site, here's one for ya. I've been collecting every receipt for things I buy the car since I had it. Just threw them in a box. I finally...
Leave a comment:
-
Ya........ this is not working with my wheels I've grinded off material just to make it not touch, and now just realizing I'd have to shave off more, the width of the wheel weight. That's... alot...
Leave a comment:
-
Correct. Fog lights do not work with your high beams on. Set by the manufacturer. It's a under-dash fuse/relay box which is the gateway between the headlight power side and the fogs. But also that the...
Leave a comment:
-
Ya. I decided I am going to grind off as much as I need to make things clear. The caliper has lots of material on that spot and you can't see that side when installed....
Leave a comment:
-
Ug... having the hardest time with this. Kind of bummed out.... My 17" wheels have a ...... "lip" as you get closer to the outside edge of the wheel. So where you would put the wheel sticky...Last edited by Raf99; 04-07-2024, 07:27 PM.
Leave a comment:
-
No diff to my knowledge. Especially for the fronts. The rear maybe one had drum brakes and one had disc right.
Leave a comment:
-
I did stop by the tuners today and showed him the pistons. He was amazed of course and was immediately said long term detonation. He asked the setup again as it's been 10 years since the initial tune...
Leave a comment:
-
Always appreciate ya stopping by
New inner drivers fender lining. This time I need to find a way to secure it better. Clean engine bay = less fasteners for this thing. At high speeds...
Leave a comment:
-
Big thanks to Jacob for helping put the engine in! I have a great method now where I don't need to tilt the engine. The trans side (no mount on) goes in the corner of the passenger side & the drivers...
Leave a comment:
-
I have this process now where I put the trans hanging off a board. The board is on a jack. I can usually get it to slide in with out much muscle.
Reason I can't take the trans...
Leave a comment:
No activity results to display
Show More
Leave a comment: