Sorry, i was moving houses but I was thinking of this. I was going to suggest it was the wiring or ECU and to ohm test the wires.
The stall at a stop is usually the IACV (not working) or a vacuum...
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
When it won't start do you have fuel and spark?
What is the condition of the plugs and wires? (What do the dugs look like? )
Any check engine light?...
Leave a comment:
-
It's the main relay most likely. Solder joints are bad and a common issue with our cars. Does your fuel pump turn on / have power?
(Wiring.... not sure. Would have to compare in a manual...
Leave a comment:
-
-
I think you'll always have a check engine light on as the body harness doesn't have all the OBDII stuff. From what i remember it's knock sensor, oil pressure sensor in a different spot, and of course...
Leave a comment:
-
Thanks for stopping by eh!! Much appreciated ! Yaaa it has launch control, speed by gear, etc. It will spin in 1st, 2nd, 3rd, but 3rd is the best gear. And I'm running pump gas (93) as that's all...
Leave a comment:
-
Awesome, I appreciate ya stopping by!
I will say the engine sounds so quiet now. It sounds like a new engine. I think the dyno runs broke in some seals and seat them with heat. And thanks...
Leave a comment:
-
We were blowing off at 17PSI and I can see why. It's a Tredstoneperformance F22 piping kit and one piece in the corner was hand made and the lip sucks. The couplers are too short for the angles. Sooo...
Leave a comment:
No activity results to display
Show More
Leave a comment: