I am looking to install a single stainless clutch line with AN fittings.
Does anyone already know thread and pitch sizes for the slave and master cylinders?
Alternate:
Buy TAS Auto Clutch Line (dampner to top mount tranny, banjo bolt)
And keep the hard line from tranny to slave cylinder.
I would remove dampner and do an adapter to -AN fittings
Question (to those that have purchased TAS clutch line):
What is the thread and pitch size of the opposite side of the banjo bolt?
And does it seperate? I know I could just throw a metric to -AN adapter.
If this has been covered, my apologies. Been looking for a few days now!
Does anyone already know thread and pitch sizes for the slave and master cylinders?
Alternate:
Buy TAS Auto Clutch Line (dampner to top mount tranny, banjo bolt)
And keep the hard line from tranny to slave cylinder.
I would remove dampner and do an adapter to -AN fittings
Question (to those that have purchased TAS clutch line):
What is the thread and pitch size of the opposite side of the banjo bolt?
And does it seperate? I know I could just throw a metric to -AN adapter.
If this has been covered, my apologies. Been looking for a few days now!
Comment