View Single Post
Old 10-09-2008, 03:25 PM   #2
bruno8747
Contributing Member
 
Join Date: Nov 2004
Location: NYC
Posts: 2,912
bruno8747 is cool... so far.
Send a message via AIM to bruno8747
It does not make sense to weld it, There are a few reasons.

Its a little hard welding the head, Its not full aluminium so thats a little tricky.

Next is, The head may warp by the intake ports if not careful.

After everything is done, you have to spend money to get the intake side milled.

The better solution would be to tap the hole of the EGR in the head and use a set screw that goes in far enough to not interfere with the intake manifold.
__________________
bruno8747 is offline   Reply With Quote