I just replaced my slave today. The method I use to get pressure when the pedal is COMPLETELY dead is:
1. Put tube onto bleeder screw into jar half filled with fluid
2. Loosen bleeder screw
3. By hand, press clutch fork to compress slave piston, then tighten bleeder.
(It's important to crack the bleeder before pressing the piston or it's not gonna work) I do this maybe 5 times at the slave, then break out the 2x4 to pump and hold the pedal to finish bleeding
But I do like the idea of running the tube to the cmc, if I ever have to do it again i'll give that a try.
short
1. Put tube onto bleeder screw into jar half filled with fluid
2. Loosen bleeder screw
3. By hand, press clutch fork to compress slave piston, then tighten bleeder.
(It's important to crack the bleeder before pressing the piston or it's not gonna work) I do this maybe 5 times at the slave, then break out the 2x4 to pump and hold the pedal to finish bleeding
But I do like the idea of running the tube to the cmc, if I ever have to do it again i'll give that a try.
short
Comment